On Fri, Apr 01, 2005 at 11:17:08AM +0200, Romano Giannetti wrote: > and nothing more. Well, this was done with the double console, so that I > will try again as soon as I have a bit of time with just the serial console > on.
Much better now. Configuration, dmesg at boot, etc are at http://www.dea.icai.upco.es/romano/linux/config-2.6.12-rc1-rg/ I booted the 2.6.12-rc1 kernel above (with the alps resume fix) with the options: console=ttyS0,115200n8 init=/bin/bash The full log of the session, if it's interesting to someone, is here: http://www.dea.icai.upco.es/romano/linux/swsusp/2612rc1-bash.s3.log The interesting part is here. At suspend I have: bash-2.05b# echo -n 3 > /proc/acpi/sleep [4294743.859000] Stopping tasks: ===| and the laptop goes off with suspend light blinking. Ok. After a 20 sec, I hit the power button and: [4294759.817000] evevent-0286: *** Error: No installed handler for fixed event [00000002] [4294759.827000] Restarting tasks... done bash-2.05b# I have the prompt back! But the HDD light is fixed on... I tried lsmod: bash-2.05b# lsmod Dead. After a bit it says: [4294828.522000] hda: dma_timer_expiry: dma status == 0x21 [4294838.522000] hda: DMA timeout error [4294838.526000] hda: dma timeout error: status=0x58 { DriveReady SeekComplete DataRequest } [4294838.536000] [4294838.538000] ide: failed opcode was: unknown [4294838.546000] hda: task_in_intr: status=0x59 { DriveReady SeekComplete DataRequest Error } [4294838.556000] hda: task_in_intr: error=0x04 { DriveStatusError } [4294838.564000] ide: failed opcode was: unknown this (with error 0x59 and 0x04) is repeated 3 more times, then: [4294838.699000] ide0: reset: success but nothing change, and after a bit: [4294858.708000] hda: dma_timer_expiry: dma status == 0x21 [4294868.708000] hda: DMA timeout error [4294868.712000] hda: dma timeout error: status=0x58 { DriveReady SeekComplete DataRequest } [4294868.722000] [4294868.724000] ide: failed opcode was: unknown [4294868.729000] hda: status error: status=0x58 { DriveReady SeekComplete DataRequest } [4294868.738000] [4294868.740000] ide: failed opcode was: unknown [4294868.746000] hda: drive not ready for command (3 more times) [4294868.862000] ide0: reset: success [4294888.879000] hda: dma_timer_expiry: dma status == 0x21 ...and continuing forever (with error 0x58 as before). In the full log there is a sysrq-m and sysrq-t result, but I do not think it's very important here. When I decided to stop I hit sysrq-b and: [4294911.707000] SysRq : Resetting The bios (with the "sony" splash) restarted but locked hard, and to resume I had to do the hard poweroff (5 seconds power button down). Well. I hope this helps someone :-). I will stay with S4 for now. Romano -- Romano Giannetti - Univ. Pontificia Comillas (Madrid, Spain) Electronic Engineer - phone +34 915 422 800 ext 2416 fax +34 915 596 569 - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/