The ADC on exynos7 is quite similar to ADCv2. The differences are as
follows:
        - exynos7-adc has 8 input channels (as against 10 in ADCv2).
        - exynos7 does not include an ADC PHY control register.
        - Some ADC_CON2 register bits being used in ADCv2 are listed as
          reserved in exynos7-adc. This results in a different init_hw
          function for exynos7.

Signed-off-by: Abhilash Kesavan <[email protected]>
---
- Based on Naveen's "iio: exynos-adc: use syscon instead of ioremap" patchset
http://comments.gmane.org/gmane.linux.kernel.iio/13943

 .../devicetree/bindings/arm/samsung/exynos-adc.txt |  2 ++
 drivers/iio/adc/exynos_adc.c                       | 32 ++++++++++++++++++++++
 2 files changed, 34 insertions(+)

diff --git a/Documentation/devicetree/bindings/arm/samsung/exynos-adc.txt 
b/Documentation/devicetree/bindings/arm/samsung/exynos-adc.txt
index c368210..f46ca9a 100644
--- a/Documentation/devicetree/bindings/arm/samsung/exynos-adc.txt
+++ b/Documentation/devicetree/bindings/arm/samsung/exynos-adc.txt
@@ -16,6 +16,8 @@ Required properties:
                                future controllers.
                        Must be "samsung,exynos3250-adc" for
                                controllers compatible with ADC of Exynos3250.
+                       Must be "samsung,exynos7-adc" for
+                               the ADC in Exynos7 and compatibles
                        Must be "samsung,s3c2410-adc" for
                                the ADC in s3c2410 and compatibles
                        Must be "samsung,s3c2416-adc" for
diff --git a/drivers/iio/adc/exynos_adc.c b/drivers/iio/adc/exynos_adc.c
index fe03177..3a2dbb3 100644
--- a/drivers/iio/adc/exynos_adc.c
+++ b/drivers/iio/adc/exynos_adc.c
@@ -390,6 +390,35 @@ static const struct exynos_adc_data exynos3250_adc_data = {
        .start_conv     = exynos_adc_v2_start_conv,
 };
 
+static void exynos_adc_exynos7_init_hw(struct exynos_adc *info)
+{
+       u32 con1, con2;
+
+       if (info->data->needs_adc_phy)
+               regmap_write(info->pmu_map, info->data->phy_offset, 1);
+
+       con1 = ADC_V2_CON1_SOFT_RESET;
+       writel(con1, ADC_V2_CON1(info->regs));
+
+       con2 = readl(ADC_V2_CON2(info->regs));
+       con2 &= ~ADC_V2_CON2_C_TIME(7);
+       con2 |= ADC_V2_CON2_C_TIME(0);
+       writel(con2, ADC_V2_CON2(info->regs));
+
+       /* Enable interrupts */
+       writel(1, ADC_V2_INT_EN(info->regs));
+}
+
+static const struct exynos_adc_data exynos7_adc_data = {
+       .num_channels   = MAX_ADC_V1_CHANNELS,
+       .mask           = ADC_DATX_MASK, /* 12 bit ADC resolution */
+
+       .init_hw        = exynos_adc_exynos7_init_hw,
+       .exit_hw        = exynos_adc_v2_exit_hw,
+       .clear_irq      = exynos_adc_v2_clear_irq,
+       .start_conv     = exynos_adc_v2_start_conv,
+};
+
 static const struct of_device_id exynos_adc_match[] = {
        {
                .compatible = "samsung,s3c2410-adc",
@@ -415,6 +444,9 @@ static const struct of_device_id exynos_adc_match[] = {
        }, {
                .compatible = "samsung,exynos3250-adc",
                .data = &exynos3250_adc_data,
+       }, {
+               .compatible = "samsung,exynos7-adc",
+               .data = &exynos7_adc_data,
        },
        {},
 };
-- 
2.1.0

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Reply via email to