Thermal sensor's clk is from pll3_usb_otg, per hardware
design requirement, need to make sure pll3_usb_otg is disabled
before STOP mode is entered, otherwise, all PFDs under it may
enter incorrect state, this patch disables pll3_usb_otg before
suspend and enables it after resume.
Signed-off-by: Anson Huang <b20...@freescale.com>
---
drivers/thermal/imx_thermal.c | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c
index 461bf3d..03894da 100644
--- a/drivers/thermal/imx_thermal.c
+++ b/drivers/thermal/imx_thermal.c
@@ -600,6 +600,8 @@ static int imx_thermal_suspend(struct device *dev)
regmap_write(map, TEMPSENSE0 + REG_CLR, TEMPSENSE0_MEASURE_TEMP);
regmap_write(map, TEMPSENSE0 + REG_SET, TEMPSENSE0_POWER_DOWN);
data->mode = THERMAL_DEVICE_DISABLED;
+ if (!IS_ERR(data->thermal_clk))
+ clk_disable_unprepare(data->thermal_clk);
return 0;
}
@@ -609,6 +611,8 @@ static int imx_thermal_resume(struct device *dev)
struct imx_thermal_data *data = dev_get_drvdata(dev);
struct regmap *map = data->tempmon;
+ if (!IS_ERR(data->thermal_clk))
+ clk_prepare_enable(data->thermal_clk);
/* Enabled thermal sensor after resume */
regmap_write(map, TEMPSENSE0 + REG_CLR, TEMPSENSE0_POWER_DOWN);
regmap_write(map, TEMPSENSE0 + REG_SET, TEMPSENSE0_MEASURE_TEMP);
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
