With the introduction of the Berlin mfd controller driver, all drivers previously sharing the chip and system controller nodes now have their own sub-node.
Signed-off-by: Antoine Tenart <[email protected]> --- arch/arm/boot/dts/berlin2q.dtsi | 53 ++++++++++++++++++++++------------------- 1 file changed, 29 insertions(+), 24 deletions(-) diff --git a/arch/arm/boot/dts/berlin2q.dtsi b/arch/arm/boot/dts/berlin2q.dtsi index 006d382d44ff..9000eb2ebc45 100644 --- a/arch/arm/boot/dts/berlin2q.dtsi +++ b/arch/arm/boot/dts/berlin2q.dtsi @@ -74,7 +74,7 @@ sdhci0: sdhci@ab0000 { compatible = "mrvl,pxav3-mmc"; reg = <0xab0000 0x200>; - clocks = <&chip CLKID_SDIO1XIN>; + clocks = <&chip_clk CLKID_SDIO1XIN>; interrupts = <GIC_SPI 17 IRQ_TYPE_LEVEL_HIGH>; status = "disabled"; }; @@ -82,7 +82,7 @@ sdhci1: sdhci@ab0800 { compatible = "mrvl,pxav3-mmc"; reg = <0xab0800 0x200>; - clocks = <&chip CLKID_SDIO1XIN>; + clocks = <&chip_clk CLKID_SDIO1XIN>; interrupts = <GIC_SPI 20 IRQ_TYPE_LEVEL_HIGH>; status = "disabled"; }; @@ -91,7 +91,7 @@ compatible = "mrvl,pxav3-mmc"; reg = <0xab1000 0x200>; interrupts = <GIC_SPI 28 IRQ_TYPE_LEVEL_HIGH>; - clocks = <&chip CLKID_NFC_ECC>, <&chip CLKID_NFC>; + clocks = <&chip_clk CLKID_NFC_ECC>, <&chip_clk CLKID_NFC>; clock-names = "io", "core"; status = "disabled"; }; @@ -112,7 +112,7 @@ local-timer@ad0600 { compatible = "arm,cortex-a9-twd-timer"; reg = <0xad0600 0x20>; - clocks = <&chip CLKID_TWD>; + clocks = <&chip_clk CLKID_TWD>; interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_HIGH)>; }; @@ -135,7 +135,7 @@ compatible = "chipidea,usb2"; reg = <0xa30000 0x10000>; interrupts = <GIC_SPI 52 IRQ_TYPE_LEVEL_HIGH>; - clocks = <&chip CLKID_USB2>; + clocks = <&chip_clk CLKID_USB2>; phys = <&usb_phy2>; phy-names = "usb-phy"; status = "disabled"; @@ -153,14 +153,14 @@ compatible = "marvell,berlin2-usb-phy"; reg = <0xb78000 0x128>; #phy-cells = <0>; - resets = <&chip 0x104 13>; + resets = <&chip_rst 0x104 13>; status = "disabled"; }; eth0: ethernet@b90000 { compatible = "marvell,pxa168-eth"; reg = <0xb90000 0x10000>; - clocks = <&chip CLKID_GETH0>; + clocks = <&chip_clk CLKID_GETH0>; interrupts = <GIC_SPI 24 IRQ_TYPE_LEVEL_HIGH>; /* set by bootloader */ local-mac-address = [00 00 00 00 00 00]; @@ -267,7 +267,7 @@ reg = <0x1400 0x100>; interrupt-parent = <&aic>; interrupts = <4>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; pinctrl-0 = <&twsi0_pmux>; pinctrl-names = "default"; status = "disabled"; @@ -280,7 +280,7 @@ reg = <0x1800 0x100>; interrupt-parent = <&aic>; interrupts = <5>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; pinctrl-0 = <&twsi1_pmux>; pinctrl-names = "default"; status = "disabled"; @@ -289,7 +289,7 @@ timer0: timer@2c00 { compatible = "snps,dw-apb-timer"; reg = <0x2c00 0x14>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; clock-names = "timer"; interrupts = <8>; }; @@ -297,14 +297,14 @@ timer1: timer@2c14 { compatible = "snps,dw-apb-timer"; reg = <0x2c14 0x14>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; clock-names = "timer"; }; timer2: timer@2c28 { compatible = "snps,dw-apb-timer"; reg = <0x2c28 0x14>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; clock-names = "timer"; status = "disabled"; }; @@ -312,7 +312,7 @@ timer3: timer@2c3c { compatible = "snps,dw-apb-timer"; reg = <0x2c3c 0x14>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; clock-names = "timer"; status = "disabled"; }; @@ -320,7 +320,7 @@ timer4: timer@2c50 { compatible = "snps,dw-apb-timer"; reg = <0x2c50 0x14>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; clock-names = "timer"; status = "disabled"; }; @@ -328,7 +328,7 @@ timer5: timer@2c64 { compatible = "snps,dw-apb-timer"; reg = <0x2c64 0x14>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; clock-names = "timer"; status = "disabled"; }; @@ -336,7 +336,7 @@ timer6: timer@2c78 { compatible = "snps,dw-apb-timer"; reg = <0x2c78 0x14>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; clock-names = "timer"; status = "disabled"; }; @@ -344,7 +344,7 @@ timer7: timer@2c8c { compatible = "snps,dw-apb-timer"; reg = <0x2c8c 0x14>; - clocks = <&chip CLKID_CFG>; + clocks = <&chip_clk CLKID_CFG>; clock-names = "timer"; status = "disabled"; }; @@ -362,9 +362,14 @@ chip: chip-controller@ea0000 { compatible = "marvell,berlin2q-chip-ctrl", "simple-mfd", "syscon"; reg = <0xea0000 0x400>, <0xdd0170 0x10>; - #clock-cells = <1>; - clocks = <&refclk>; - clock-names = "refclk"; + + chip_clk: clock { + compatible = "marvell,berlin2q-clk"; + + #clock-cells = <1>; + clocks = <&refclk>; + clock-names = "refclk"; + }; soc_pinctrl: pin-controller { compatible = "marvell,berlin2q-soc-pinctrl"; @@ -390,7 +395,7 @@ compatible = "marvell,berlin2q-ahci", "generic-ahci"; reg = <0xe90000 0x1000>; interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>; - clocks = <&chip CLKID_SATA>; + clocks = <&chip_clk CLKID_SATA>; #address-cells = <1>; #size-cells = <0>; @@ -410,7 +415,7 @@ sata_phy: phy@e900a0 { compatible = "marvell,berlin2q-sata-phy"; reg = <0xe900a0 0x200>; - clocks = <&chip CLKID_SATA>; + clocks = <&chip_clk CLKID_SATA>; #address-cells = <1>; #size-cells = <0>; #phy-cells = <1>; @@ -429,7 +434,7 @@ compatible = "chipidea,usb2"; reg = <0xed0000 0x10000>; interrupts = <GIC_SPI 11 IRQ_TYPE_LEVEL_HIGH>; - clocks = <&chip CLKID_USB0>; + clocks = <&chip_clk CLKID_USB0>; phys = <&usb_phy0>; phy-names = "usb-phy"; status = "disabled"; @@ -439,7 +444,7 @@ compatible = "chipidea,usb2"; reg = <0xee0000 0x10000>; interrupts = <GIC_SPI 12 IRQ_TYPE_LEVEL_HIGH>; - clocks = <&chip CLKID_USB1>; + clocks = <&chip_clk CLKID_USB1>; phys = <&usb_phy1>; phy-names = "usb-phy"; status = "disabled"; -- 2.3.5 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
