An oops exists in the flow of stmmac_release().
phy_ethtool_get_wol() depends on phydev->drv.
phydev->drv will be null after stmmac_mdio_unreg() completes.
Steps to reproduce on Quark X1000:
1. ifconfig eth0 192.168.0.1
2. rmmod stmmac_pci
To fix this stmmac_mdio_unreg() should be run after unregister_netdev().
Signed-off-by: Bryan O'Donoghue <pure.lo...@nexus-software.ie>
Reported-by: Dan O'Donovan <dan.odono...@emutex.com>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index a0ea84f..3ab3e4a8 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -2958,14 +2958,14 @@ int stmmac_dvr_remove(struct net_device *ndev)
priv->hw->dma->stop_tx(priv->ioaddr);
stmmac_set_mac(priv->ioaddr, false);
- if (priv->pcs != STMMAC_PCS_RGMII && priv->pcs != STMMAC_PCS_TBI &&
- priv->pcs != STMMAC_PCS_RTBI)
- stmmac_mdio_unregister(ndev);
netif_carrier_off(ndev);
unregister_netdev(ndev);
if (priv->stmmac_rst)
reset_control_assert(priv->stmmac_rst);
clk_disable_unprepare(priv->stmmac_clk);
+ if (priv->pcs != STMMAC_PCS_RGMII && priv->pcs != STMMAC_PCS_TBI &&
+ priv->pcs != STMMAC_PCS_RTBI)
+ stmmac_mdio_unregister(ndev);
free_netdev(ndev);
return 0;
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
