Kbuild should descend into drivers/pinctrl/ only when CONFIG_PINCTRL is enabled because everything under that directory depends on CONFIG_PINCTRL.
We can avoid the conditional, ifeq ($(CONFIG_OF),y) ... endif. Signed-off-by: Masahiro Yamada <[email protected]> --- drivers/Makefile | 2 +- drivers/pinctrl/Makefile | 6 ++---- 2 files changed, 3 insertions(+), 5 deletions(-) diff --git a/drivers/Makefile b/drivers/Makefile index b64b49f..e4b260e 100644 --- a/drivers/Makefile +++ b/drivers/Makefile @@ -11,7 +11,7 @@ obj-y += bus/ obj-$(CONFIG_GENERIC_PHY) += phy/ # GPIO must come after pinctrl as gpios may need to mux pins etc -obj-y += pinctrl/ +obj-$(CONFIG_PINCTRL) += pinctrl/ obj-y += gpio/ obj-y += pwm/ obj-$(CONFIG_PCI) += pci/ diff --git a/drivers/pinctrl/Makefile b/drivers/pinctrl/Makefile index f6710a8..76ba976 100644 --- a/drivers/pinctrl/Makefile +++ b/drivers/pinctrl/Makefile @@ -2,12 +2,10 @@ subdir-ccflags-$(CONFIG_DEBUG_PINCTRL) += -DDEBUG -obj-$(CONFIG_PINCTRL) += core.o pinctrl-utils.o +obj-y += core.o pinctrl-utils.o obj-$(CONFIG_PINMUX) += pinmux.o obj-$(CONFIG_PINCONF) += pinconf.o -ifeq ($(CONFIG_OF),y) -obj-$(CONFIG_PINCTRL) += devicetree.o -endif +obj-$(CONFIG_OF) += devicetree.o obj-$(CONFIG_GENERIC_PINCONF) += pinconf-generic.o obj-$(CONFIG_PINCTRL_ADI2) += pinctrl-adi2.o obj-$(CONFIG_PINCTRL_AS3722) += pinctrl-as3722.o -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
