On Fri, Jul 10, 2015 at 03:58:36PM +0800, Shengjiu Wang wrote:
> On Fri, Jul 10, 2015 at 01:28:07PM +0530, Vinod Koul wrote:
> > On Tue, Jul 07, 2015 at 05:20:04PM +0800, Shengjiu Wang wrote:
> >
> > > +/*
> > > + * p_2_p watermark_level description
> > > + * Bits Name Description
> > > + * 0-7 Lower WML Lower watermark level
> > > + * 8 PS 1: Pad Swallowing
> > > + * 0: No Pad Swallowing
> > > + * 9 PA 1: Pad Adding
> > > + * 0: No Pad Adding
> > > + * 10 SPDIF If this bit is set both
> > > source
> > > + * and destination are on
> > > SPBA
> > > + * 11 Source Bit(SP) 1: Source on SPBA
> > > + * 0: Source on AIPS
> > > + * 12 Destination Bit(DP) 1: Destination on SPBA
> > > + * 0: Destination on AIPS
> > > + * 13-15 --------- MUST BE 0
> > > + * 16-23 Higher WML HWML
> > > + * 24-27 N Total number of samples
> > > after
> > > + * which Pad
> > > adding/Swallowing
> > > + * must be done. It must
> > > be odd.
> > > + * 28 Lower WML Event(LWE) SDMA events reg to
> > > check for
> > > + * LWML event mask
> > > + * 0: LWE in EVENTS
> > > register
> > > + * 1: LWE in EVENTS2
> > > register
> > > + * 29 Higher WML Event(HWE) SDMA events reg to
> > > check for
> > > + * HWML event mask
> > > + * 0: HWE in EVENTS
> > > register
> > > + * 1: HWE in EVENTS2
> > > register
> > > + * 30 --------- MUST BE 0
> > > + * 31 CONT 1: Amount of samples to
> > > be
> > > + * transferred is unknown
> > > and
> > > + * script will keep on
> > > + * transferring samples as
> > > long as
> > > + * both events are
> > > detected and
> > > + * script must be manually
> > > stopped
> > > + * by the application
> > > + * 0: The amount of
> > > samples to be
> > > + * transferred is equal to
> > > the
> > > + * count field of mode word
> > > + */
> > > +static void sdma_set_watermarklevel_for_p2p(struct sdma_channel *sdmac)
> > > +{
> > > + struct sdma_engine *sdma = sdmac->sdma;
> > > +
> > > + int lwml = sdmac->watermark_level & 0xff;
> > > + int hwml = (sdmac->watermark_level >> 16) & 0xff;
> > > +
> > > + __set_bit(sdmac->event_id0 % 32, &sdmac->event_mask[1]);
> > > + __set_bit(sdmac->event_id1 % 32, &sdmac->event_mask[0]);
> > > +
> > > + if (sdmac->event_id0 > 31)
> > > + __set_bit(28, &sdmac->watermark_level);
> > > +
> > > + if (sdmac->event_id1 > 31)
> > > + __set_bit(29, &sdmac->watermark_level);
> > > +
> > > + /*
> > > + * If LWML(src_maxburst) > HWML(dst_maxburst), we need
> > > + * swap LWML and HWML of INFO(A.3.2.5.1), also need swap
> > > + * r0(event_mask[1]) and r1(event_mask[0]).
> > > + */
> > > + if (lwml > hwml) {
> > > + sdmac->watermark_level &= ~0xff00ff;
> > > + sdmac->watermark_level |= hwml;
> > > + sdmac->watermark_level |= lwml << 16;
> > > + swap(sdmac->event_mask[0], sdmac->event_mask[1]);
> > so typical practice is to define macros for these. For example above can be
> > defined as
> > #define SDMA_WATERMARK_LWML BIT(X)
> > #define SDMA_WATERMARK_PA BIT(Y)
> >
> > Then here you can say
> > sdmac->watermark_level &= SDMA_WATERMARK_PA | ....
> >
> > That way it is easier to read, review and maintain
> >
> >
> > > + }
> > > +
> > > + if (sdmac->per_address2 >= sdma->spba_start_addr &&
> > > + sdmac->per_address2 <= sdma->spba_end_addr)
> > > + __set_bit(11, &sdmac->watermark_level);
> > > +
> > > + if (sdmac->per_address >= sdma->spba_start_addr &&
> > > + sdmac->per_address <= sdma->spba_end_addr)
> > > + __set_bit(12, &sdmac->watermark_level);
> > > +
> > > + __set_bit(31, &sdmac->watermark_level);
> > All these and few more below will look much better by have defines above
> >
> > > @@ -1221,6 +1311,14 @@ static int sdma_config(struct dma_chan *chan,
> > > sdmac->watermark_level = dmaengine_cfg->src_maxburst *
> > > dmaengine_cfg->src_addr_width;
> > > sdmac->word_size = dmaengine_cfg->src_addr_width;
> > > + } else if (dmaengine_cfg->direction == DMA_DEV_TO_DEV) {
> > > + sdmac->per_address2 = dmaengine_cfg->src_addr;
> > > + sdmac->per_address = dmaengine_cfg->dst_addr;
> > > + sdmac->watermark_level =
> > > + dmaengine_cfg->src_maxburst & 0xff;
> > > + sdmac->watermark_level |=
> > > + (dmaengine_cfg->dst_maxburst & 0xff) << 16;
> > > + sdmac->word_size = dmaengine_cfg->dst_addr_width;
> > Please fix this as well
> >
> I will refine this patch and send V3 for review. Thanks
>
> best regards
> wang shengjiu
> > --
> > ~Vinod
Hi Vinod
V3 for this patch has been sent, please review. Thanks.
Best regards
Wang Shengjiu
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
