Hi Geert,
On 19/02/12 20:17, Geert Uytterhoeven wrote:
On Fri, Feb 10, 2012 at 07:14,<[email protected]> wrote:
The classic m68k code has always supported an FPU (although it may have
been a software emulated one). The non-MMU m68k code has never supported FPU
hardware. To help in merging common code create a configation setting that
signifies if we are builing in FPU support or not.
This switch, CONFIG_FPU, is set as per the current use cases. So it is
always enabled if CONFIG_MMU is set, and disabled otherwise. With a little
extra code it will be possible to disable it on the classic m68k platforms
as well, and to enable it on non-MMU platforms that do have hardware FPU.
Signed-off-by: Greg Ungerer<[email protected]>
Acked-by: Geert Uytterhoeven<[email protected]>
Thanks!
Regards
Greg
------------------------------------------------------------------------
Greg Ungerer -- Principal Engineer EMAIL: [email protected]
SnapGear Group, McAfee PHONE: +61 7 3435 2888
8 Gardner Close FAX: +61 7 3217 5323
Milton, QLD, 4064, Australia WEB: http://www.SnapGear.com
--
To unsubscribe from this list: send the line "unsubscribe linux-m68k" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
