On 7/1/19 10:04 AM, Sakari Ailus wrote:
> Hi Marek,
>
> On Mon, May 20, 2019 at 10:18:11PM +0200, Marek Vasut wrote:
>> Add bindings for the Intersil ISL7998x BT656-to-MIPI-CSI2 decoder.
>>
>> Signed-off-by: Marek Vasut <[email protected]>
>> Cc: Sakari Ailus <[email protected]>
>> Cc: Mauro Carvalho Chehab <[email protected]>
>> Cc: Rob Herring <[email protected]>
>> Cc: [email protected]
>> To: [email protected]
>> ---
>> .../bindings/media/i2c/isl7998x.txt | 37 +++++++++++++++++++
>> 1 file changed, 37 insertions(+)
>> create mode 100644 Documentation/devicetree/bindings/media/i2c/isl7998x.txt
>>
>> diff --git a/Documentation/devicetree/bindings/media/i2c/isl7998x.txt
>> b/Documentation/devicetree/bindings/media/i2c/isl7998x.txt
>> new file mode 100644
>> index 000000000000..c21703983360
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/media/i2c/isl7998x.txt
>> @@ -0,0 +1,37 @@
>> +Intersil ISL7998x BT656-to-MIPI-CSI2 decoder
>> +
>> +The Intersil ISL7998x is a BT656-to-MIPI-CSI decoder which, capable of
>> +receiving up to four analog stream and multiplexing them into up to four
>> +MIPI CSI2 virtual channels, using one MIPI clock lane and 1/2 data lanes.
>> +
>> +Required Properties:
>> +- compatible: value should be "isil,isl79987"
>> +- pd-gpios: a GPIO spec for the Power Down pin (active high)
>> +
>> +Option Properties:
>> +- isil,num-inputs: Number of connected inputs (1, 2 or 4)
>
> The presence of ports describing connected Bt.656 inputs tells this.
>
>> +
>> +For further reading on port node refer to
>> +Documentation/devicetree/bindings/media/video-interfaces.txt.
>
> Which endpoint properties are relevant for the endpoint(s) in the CSI-2 port?
clock-lanes, data-lanes and the remote-endpoint .
> How about the ports describing the Bt.656 interfaces? You should have
> those, too...
So who would be connected to these analog "input" endpoint ? What would
be their "remote-endpoint" ?
>> +
>> +Example:
>> +
>> + i2c_master {
>> + isl7998x_mipi@44 {
>> + compatible = "isil,isl79987";
>> + reg = <0x44>;
>> + isil,num-inputs = <4>;
>> + pinctrl-names = "default";
>> + pinctrl-0 = <&pinctrl_videoadc>;
>> + pd-gpios = <&gpio3 27 GPIO_ACTIVE_HIGH>;
>> + status = "okay";
>> +
>> + port {
>> + isl79987_to_mipi_csi2: endpoint {
>> + remote-endpoint = <&mipi_csi2_in>;
>> + clock-lanes = <0>;
>> + data-lanes = <1 2>;
>> + };
>> + };
>> + };
>> + };
>>
>
--
Best regards,
Marek Vasut
