>On Wed, 10 Jun 2009, Karicheri, Muralidharan wrote: > >> So how do I know what frame-rate I get? Sensor output frame rate depends >> on the resolution of the frame, blanking, exposure time etc. > >This is not supported. > I am still not clear. You had said in an earlier email that it can support streaming. That means application can stream frames from the capture device. I know you don't have support for setting a specific frame rate, but it must be outputting frame at some rate right?
Here is my usecase. open capture device, set resolutions (say VGA) for capture (S_FMT ???) request buffer for streaming & mmap & QUERYBUF start streaming (STREAMON) DQBUF/QBUF in a loop -> get VGA buffers at some fps. STREAMOFF close device Is this possible with mt9t031 available currently in the tree? This requires sensor device output frames continuously on the bus using PCLK/HSYNC/VSYNC timing to the bridge device connected to the bus. Can you give a use case like above that you are using. I just want to estimate how much effort is required to add this support in the mt9t031 driver. Thanks Murali >Thanks >Guennadi >--- >Guennadi Liakhovetski, Ph.D. >Freelance Open-Source Software Developer >http://www.open-technology.de/ -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
