On 18/09/2017 17:33, Måns Rullgård wrote: > Marc Gonzalez writes: > >> diff --git a/drivers/media/rc/Kconfig b/drivers/media/rc/Kconfig >> index d9ce8ff55d0c..f84923289964 100644 >> --- a/drivers/media/rc/Kconfig >> +++ b/drivers/media/rc/Kconfig >> @@ -469,6 +469,11 @@ config IR_SIR >> To compile this driver as a module, choose M here: the module will >> be called sir-ir. >> +config IR_TANGO >> + tristate "Sigma Designs SMP86xx IR decoder" >> + depends on RC_CORE >> + depends on ARCH_TANGO || COMPILE_TEST >> + >> config IR_ZX >> tristate "ZTE ZX IR remote control" >> depends on RC_CORE > > This hunk looks damaged.
It appears that the SMTP server has been mangling outgoing messages for a few months. I will find a work-around. > What have you changed compared to my original code? o Rename tangox to tango o Handle protocol selection (enable/disable) in the change_protocol callback, instead of unconditionally in open/close o Delete open/close callbacks o Rebase driver on top of linuxtv/master o Use ir_nec_bytes_to_scancode() in tango_ir_handle_nec() o Use devm_rc_allocate_device() in tango_ir_probe() o Use Use devm_rc_register_device() in tango_ir_probe() o Rename rc->input_name to rc->device_name o List all NEC variants for rc->allowed_protocols o Change type of clkrate to u64 o Fix tango_ir_probe and tango_ir_remove for devm o Move around some init calls in tango_ir_probe() for devm o Use relaxed variants of MMIO accessors > I tested all three protocols with a few random remotes I had lying > around back when I wrote the driver, but that's quite a while ago. OK, I don't think I changed anything wrt RC-5 and RC-6 handling. It would be great if you could give the driver a quick spin to check these two protocols. But if you don't have time, no problem. > You should also write a devicetree binding. Will do. > Finally, when sending patches essentially written by someone else, > please make sure to set a From: line for correct attribution. It's not > nice to take other people's code and apparently pass it off as your own > even you've made a few small changes. It was not my intent to "take other people's code and apparently pass it off as my own". I clearly stated where I got the driver from, and your copyright notice is right there, at the top of the driver. But I understand that you also want to be credited as the author in the git log, and I will fix that in v2. Please accept my apologies. Regards.
