Hi Hugues,
On Wed, Jan 10, 2018 at 03:51:07PM +0000, Hugues FRUCHET wrote:
> Good news Maxime !
>
> Have you seen that you can adapt the polarities through devicetree ?
>
> + /* Parallel bus endpoint */
> + ov5640_to_parallel: endpoint {
> [...]
> + hsync-active = <0>;
> + vsync-active = <0>;
> + pclk-sample = <1>;
> + };
>
> Doing so you can adapt to your SoC/board setup easily.
>
> If you don't put those lines in devicetree, the ov5640 default init
> sequence is used which set the polarity as defined in below comment:
> ov5640_set_stream_dvp()
> [...]
> + * Control lines polarity can be configured through
> + * devicetree endpoint control lines properties.
> + * If no endpoint control lines properties are set,
> + * polarity will be as below:
> + * - VSYNC: active high
> + * - HREF: active low
> + * - PCLK: active low
> + */
> [...]
The properties are at the moment documented as mandatory in DT binding
documentation.
--
Sakari Ailus
e-mail: [email protected]
