Hi all,
the remote on my TechnoTrend CT2-4500 is not working with kernel 4.18.
The TV-card itself works fine:
cx25840 6-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes)
cx23885: cx23885_dvb_register() allocating 1 frontend(s)
cx23885: cx23885[0]: cx23885 based dvb card
i2c i2c-5: Added multiplexed i2c bus 12
si2168 5-0064: Silicon Labs Si2168-B40 successfully identified
si2168 5-0064: firmware version: B 4.0.2
si2157 12-0060: Silicon Labs Si2147/2148/2157/2158 successfully attached
dvbdev: DVB: registering new adapter (cx23885[0])
cx23885 0000:17:00.0: DVB: registering adapter 0 frontend 0 (Silicon
Labs Si2168)...
sp2 4-0040: CIMaX SP2 successfully attached
cx23885: Technotrend TT-budget CT2-4500 CI MAC address: bc:ea:2b:45:05:68
cx23885: cx23885_dev_checkrevision() Hardware revision = 0xa5
cx23885: cx23885[0]/0: found at 0000:17:00.0, rev: 4, irq: 31, latency:
0, mmio: 0xfe000000
The remote is registered:
Registered IR keymap rc-fusionhdtv-mce
rc rc0: FusionHDTV as
/devices/pci0000:00/0000:00:01.2/0000:15:00.2/0000:16:00.0/0000:17:00.0/i2c-4/4-006b/rc/rc0
input: FusionHDTV as
/devices/pci0000:00/0000:00:01.2/0000:15:00.2/0000:16:00.0/0000:17:00.0/i2c-4/4-006b/rc/rc0/input18
rc rc0: lirc_dev: driver ir_kbd_i2c registered at minor = 0, scancode
receiver, no transmitter
ir-keytable reports:
Found /sys/class/rc/rc0/ (/dev/input/event15) with:
Name: FusionHDTV
Driver: ir_kbd_i2c, table: rc-fusionhdtv-mce
lirc device: /dev/lirc0
Supported protocols: unknown
Enabled protocols: unknown
bus: 24, vendor/product: 0000:0000, version: 0x0000
Repeat delay = 500 ms, repeat period = 125 ms
Apparently, no protocols are reported.
evtest on /dev/input/event15 reports no events.
The error was reported before:
http://lirc.10951.n7.nabble.com/Problems-with-cx23885-IR-receiver-td10884.html
The remote is working, I verified it with a camera.
Regards,
Martin
