From: Dongchun Zhu <>


Add a v4l2 sub-device driver for Dongwoon's DW9768 lens voice coil.
This is a voice coil module using the i2c bus to control the focus position.

The DW9768 can control the position with 10 bits value and
consists of two 8 bit registers show as below.
register 0x04(DW9768_REG_POSITION):
register 0x03:

This driver supports:
 - set DW9768 to standby mode once suspend and turn it back to active if resume
 - set the position via V4L2_CID_FOCUS_ABSOLUTE ctrl

Mainly changes of v2 are addressing the comments from Tomasz, Bingbu, Andy,
 - Use i2c_smbus_write_byte_data/i2c_smbus_write_block_data to write I2C 
 - Adopt the runtime PM suspend/resume callbacks to powering off/on
 - Check the PM runtime status before powering off in dw9768_remove function
 - Add one more regulator vin for the I2C interface
 - Remove or refine redundant log print
 - Fix other reviewed issues in v1

Dongchun Zhu (2):
  media: i2c: dw9768: Add DT support and MAINTAINERS entry
  media: i2c: Add DW9768 VCM driver

 .../bindings/media/i2c/dongwoon,dw9768.txt         |   9 +
 MAINTAINERS                                        |   8 +
 drivers/media/i2c/Kconfig                          |  10 +
 drivers/media/i2c/Makefile                         |   1 +
 drivers/media/i2c/dw9768.c                         | 349 +++++++++++++++++++++
 5 files changed, 377 insertions(+)
 create mode 100644 
 create mode 100644 drivers/media/i2c/dw9768.c


Reply via email to