Hello! I need a small help.
I have a remote control that was detected by kernel with the help of
"ir-kbd-i2c".
At least it was in Ubuntu 9.04.
But now in Ubuntu 10.10 and kernel 2.6.35-26 it isn't detected. I load
"ir-kbd-i2c"
module but it doesn't give any output to dmesg as before.
Any idea?
> Date: Tue, 30 Nov 2010 13:53:12 +0100
>
>
>
> Hello!
>
> I have a new remote control to add to the list of remotes supported by linux.
> It's detected
> by kernel and almost running. DVB-T card and bundled receiver work fine.
>
> But I'm a newbie and I would need some help with my remote. I'm about to find
> the solution but
> I don't know the next step of the process.
>
> Hardware:
> Remote: TV713X
> TV-Card: Conceptronic CTVCOMBOi (detected as Tevion/KWorld DVB-T 220RF)
> Receiver: bundled in the TV-Card
> Software: Ubuntu 9.04
>
> dmesg:
>
> [ 8.932913] saa7130/34: v4l2 driver version 0.2.14 loaded
> [ 8.933488] saa7134 0000:01:06.0: PCI INT A -> Link[LNKA] -> GSI 19
> (level, low) -> IRQ 19
> [ 8.933494] saa7133[0]: found at 0000:01:06.0, rev: 209, irq: 19, latency:
> 64, mmio: 0xdffff800
> [ 8.933499] saa7133[0]: subsystem: 17de:7201, board: Tevion/KWorld DVB-T
> 220RF [card=88,autodetected]
...
> sudo modprobe ir-kbd-i2c
> WARNING: All config files need .conf: /etc/modprobe.d/oss-compat, it will be
> ignored in a future release.
>
> The output in dmesg is:
> [ 374.444695] input: i2c IR (KNC One) as /devices/virtual/input/input6
> [ 374.472666] ir-kbd-i2c: i2c IR (KNC One) detected at i2c-0/0-0030/ir0
> [saa7133[0]]
>
> And, what is more. Only when the module is loaded, if I push some buttons of
> the remote I have this
> output in dmesg:
> [ 450.228029] i2c IR (KNC One): unknown key: key=0x03 raw=0x03 down=1
> [ 450.288526] i2c IR (KNC One): unknown key: key=0x03 raw=0x03 down=0
> [ 451.248534] i2c IR (KNC One): unknown key: key=0x00 raw=0x00 down=1
> [ 451.308027] i2c IR (KNC One): unknown key: key=0x00 raw=0x00 down=0
>
