Hi all First of all, please if I'm on the wrong list tell me which is correct.
I bought a new TV-card "MyGica X8507" if I set it up as DMB-TH Mygica X8506 "card 22" analog TV I can see but not hear. Can you help me to configure this card so I can listen? I hope that soon this support and can also see digital television. Thanks in advance ____________________________________________________________________ http://www.linuxtv.org/wiki/index.php/Geniatech/MyGica_X8507_PCI-Express_Hybrid_Card ____________________________________________________________________ dmesg [ 8.769368] Linux video capture interface: v2.00 [ 8.782879] cx23885 driver version 0.0.2 loaded [ 8.784037] cx23885 0000:02:00.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19 [ 8.784041] cx23885[0]/0: cx23885_dev_setup() Memory configured for PCIe bridge type 885 [ 8.784043] cx23885[0]/0: cx23885_init_tsport(portno=1) [ 8.784223] CORE cx23885[0]: subsystem: 14f1:8502, board: Mygica X8506 DMB-TH [card=22,insmod option] [ 8.784226] cx23885[0]/0: cx23885_pci_quirks() [ 8.784230] cx23885[0]/0: cx23885_dev_setup() tuner_type = 0x4c tuner_addr = 0x61 [ 8.784233] cx23885[0]/0: cx23885_dev_setup() radio_type = 0x0 radio_addr = 0x0 [ 8.784235] cx23885[0]/0: cx23885_reset() [ 8.892926] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [VID A] [ 8.892930] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch2] [ 8.892932] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [TS1 B] [ 8.892935] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch4] [ 8.892937] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch5] [ 8.892939] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [TS2 C] [ 8.892953] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch7] [ 8.892955] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch8] [ 8.892957] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch9] [ 9.131075] cx23885[0]: scan bus 0: [ 9.133467] cx23885[0]: i2c scan: found device @ 0x20 [???] [ 9.138377] cx23885[0]: i2c scan: found device @ 0x66 [???] [ 9.144733] cx23885[0]: i2c scan: found device @ 0xa0 [eeprom] [ 9.144876] cx23885[0]: i2c scan: found device @ 0xa2 [???] [ 9.146071] cx23885[0]: i2c scan: found device @ 0xa4 [???] [ 9.146214] cx23885[0]: i2c scan: found device @ 0xa6 [???] [ 9.146355] cx23885[0]: i2c scan: found device @ 0xa8 [???] [ 9.146496] cx23885[0]: i2c scan: found device @ 0xaa [???] [ 9.146637] cx23885[0]: i2c scan: found device @ 0xac [???] [ 9.146778] cx23885[0]: i2c scan: found device @ 0xae [???] [ 9.152627] cx23885[0]: scan bus 1: [ 9.168325] cx23885[0]: i2c scan: found device @ 0xc2 [tuner/mt2131/tda8275/xc5000/xc3028] [ 9.173738] cx23885[0]: scan bus 2: [ 9.184143] cx23885[0]: i2c scan: found device @ 0x66 [???] [ 9.184795] cx23885[0]: i2c scan: found device @ 0x88 [cx25837] [ 9.185099] cx23885[0]: i2c scan: found device @ 0x98 [???] [ 9.292405] cx25840 5-0044: cx23885 A/V decoder found @ 0x88 (cx23885[0]) [ 9.302242] cx25840 5-0044: firmware: requesting v4l-cx23885-avcore-01.fw [ 10.374232] cx25840 5-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes) [ 10.380657] cx23885[0]/0: cx23885_video_register() [ 10.382438] tuner 4-0061: chip found @ 0xc2 (cx23885[0]) [ 10.553069] xc5000 4-0061: creating new instance [ 10.553766] xc5000: Successfully identified at address 0x61 [ 10.553768] xc5000: Firmware has not been loaded previously [ 10.553770] cx23885[0]/0: cx23885_vdev_init() [ 10.553828] cx23885[0]/0: registered device video1 [v4l2] [ 10.553831] cx23885[0]/0: cx23885_set_tvnorm(norm = 0x00001000) name: [NTSC-M] [ 10.559271] xc5000: waiting for firmware upload (dvb-fe-xc5000-1.6.114.fw)... [ 10.559274] cx23885 0000:02:00.0: firmware: requesting dvb-fe-xc5000-1.6.114.fw [ 10.692589] xc5000: firmware read 12401 bytes. [ 10.692591] xc5000: firmware uploading... [ 12.066004] xc5000: firmware upload complete... [ 12.707015] cx23885[0]/0: cx23885_set_control() calling cx25840(VIDIOC_S_CTRL) (disabled - no action) [ 12.707017] cx23885[0]/0: cx23885_set_control() calling cx25840(VIDIOC_S_CTRL) (disabled - no action) [ 12.707019] cx23885[0]/0: cx23885_set_control() calling cx25840(VIDIOC_S_CTRL) (disabled - no action) [ 12.707022] cx23885[0]/0: cx23885_set_control() calling cx25840(VIDIOC_S_CTRL) (disabled - no action) [ 12.707024] cx23885[0]/0: cx23885_set_control() calling cx25840(VIDIOC_S_CTRL) (disabled - no action) [ 12.707026] cx23885[0]/0: cx23885_set_control() calling cx25840(VIDIOC_S_CTRL) (disabled - no action) [ 12.707029] cx23885[0]/0: cx23885_video_mux() video_mux: 0 [vmux=2, gpio=0x0,0x0,0x0,0x0] [ 12.711091] cx23885_dvb_register() allocating 1 frontend(s) [ 12.711094] cx23885[0]: cx23885 based dvb card [ 12.750805] xc5000 4-0061: attaching existing instance [ 12.751535] xc5000: Successfully identified at address 0x61 [ 12.751536] xc5000: Firmware has been loaded previously [ 12.751540] DVB: registering new adapter (cx23885[0]) [ 12.751544] DVB: registering adapter 0 frontend 0 (Legend Silicon LGS8913/LGS8GXX DMB-TH)... [ 12.751815] cx23885_dev_checkrevision() Hardware revision = 0xb0 [ 12.751824] cx23885[0]/0: found at 0000:02:00.0, rev: 2, irq: 19, latency: 0, mmio: 0xfd600000 [ 12.751831] cx23885 0000:02:00.0: setting latency timer to 64 [ 12.751836] IRQ 19/cx23885[0]: IRQF_DISABLED is not guaranteed on shared IRQs [ 12.754419] cx23885[0]/0: open dev=video1 radio=0 type=vid-cap [ 12.754424] cx23885[0]/0: post videobuf_queue_init() [ 19.342718] cx23885[0]/0: open dev=video1 radio=0 type=vid-cap [ 19.342723] cx23885[0]/0: post videobuf_queue_init() ____________________________________________________________________ lspci -vvvnn 02:00.0 Multimedia video controller [0400]: Conexant Systems, Inc. CX23885 PCI Video and Audio Decoder [14f1:8852] (rev 02) Subsystem: Conexant Systems, Inc. Device [14f1:8502] Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 0, Cache Line Size: 4 bytes Interrupt: pin A routed to IRQ 19 Region 0: Memory at fd600000 (64-bit, non-prefetchable) [size=2M] Capabilities: [40] Express (v1) Endpoint, MSI 00 DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s <64ns, L1 <1us ExtTag- AttnBtn- AttnInd- PwrInd- RBE- FLReset- DevCtl: Report errors: Correctable- Non-Fatal- Fatal- Unsupported- RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+ MaxPayload 128 bytes, MaxReadReq 512 bytes DevSta: CorrErr- UncorrErr+ FatalErr- UnsuppReq+ AuxPwr- TransPend- LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1, Latency L0 <2us, L1 <4us ClockPM- Surprise- LLActRep- BwNot- LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- Retrain- CommClk+ ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt- LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt- Capabilities: [80] Power Management version 2 Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- Capabilities: [90] Vital Product Data Product Name: " End Capabilities: [a0] MSI: Enable- Count=1/1 Maskable- 64bit+ Address: 0000000000000000 Data: 0000 Capabilities: [100 v1] Advanced Error Reporting UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq+ ACSViol- UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol- UESvrt: DLP+ SDES- TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol- CESta: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr- CEMsk: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr- AERCap: First Error Pointer: 14, GenCap- CGenEn- ChkCap- ChkEn- Capabilities: [200 v1] Virtual Channel Caps: LPEVC=0 RefClk=100ns PATEntryBits=1 Arb: Fixed+ WRR32+ WRR64+ WRR128- Ctrl: ArbSelect=WRR64 Status: InProgress- Port Arbitration Table [240] <?> VC0: Caps: PATOffset=00 MaxTimeSlots=1 RejSnoopTrans- Arb: Fixed- WRR32- WRR64- WRR128- TWRR128- WRR256- Ctrl: Enable+ ID=0 ArbSelect=Fixed TC/VC=ff Status: NegoPending- InProgress- Kernel driver in use: cx23885 Thanks in advance -- Dona tu voz http://www.voxforge.org/es -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
