Hi Antti,
Smatch complains about a potential information leak. I was hoping you
could take a look.
The patch de8e42035014: "[media] tda10071: NXP TDA10071 DVB-S/S2
driver" from Aug 1, 2011, leads to the following warning:
drivers/media/dvb/frontends/tda10071.c:322
tda10071_diseqc_send_master_cmd()
error: memcpy() 'diseqc_cmd->msg' too small (6 vs 16)
drivers/media/dvb/frontends/tda10071.c
290 if (diseqc_cmd->msg_len < 3 || diseqc_cmd->msg_len > 16) {
^^^^^^^^^^^^^^^^^^^^^^^^
We cap ->msg_len at 16 here. I wasn't able to figure out where the 16
came from. Or the 3 for that matter.
291 ret = -EINVAL;
292 goto error;
293 }
294
295 /* wait LNB TX */
296 for (i = 500, tmp = 0; i && !tmp; i--) {
297 ret = tda10071_rd_reg_mask(priv, 0x47, &tmp, 0x01);
298 if (ret)
299 goto error;
300
301 usleep_range(10000, 20000);
302 }
303
304 dbg("%s: loop=%d", __func__, i);
305
306 if (i == 0) {
307 ret = -ETIMEDOUT;
308 goto error;
309 }
310
311 ret = tda10071_wr_reg_mask(priv, 0x47, 0x00, 0x01);
312 if (ret)
313 goto error;
314
315 cmd.args[0x00] = CMD_LNB_SEND_DISEQC;
316 cmd.args[0x01] = 0;
317 cmd.args[0x02] = 0;
318 cmd.args[0x03] = 0;
319 cmd.args[0x04] = 2;
320 cmd.args[0x05] = 0;
321 cmd.args[0x06] = diseqc_cmd->msg_len;
322 memcpy(&cmd.args[0x07], diseqc_cmd->msg, diseqc_cmd->msg_len);
^^^^^^^^^^^^^^^
->msg is only 6 bytes long so we're copying past the end of the array.
Also cmd.arg is 0x1e (30) bytes long and we only copy 0x07 + 16 bytes
into it so it leaves the last 7 bytes of cmd.args unitialized. Btw,
why are the sizes specified in hex instead of decimal here?
323 cmd.len = 0x07 + diseqc_cmd->msg_len;
regards,
dan carpenter
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
