Hi, Am 30.12.2013 11:10, schrieb Rudy Zijlstra: > Dear List, > > I have a DVB card as mentioned in the subject > > 03:00.0 Multimedia controller [0480]: Device [dd01:0003] > Subsystem: Device [dd01:0021] > Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- > Stepping- SERR- FastB2B- DisINTx+ > Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- > <TAbort- <MAbort- >SERR- <PERR- INTx- > Interrupt: pin A routed to IRQ 17 > Region 0: Memory at f0900000 (64-bit, non-prefetchable) [size=64K] > Capabilities: [50] Power Management version 3 > Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA > PME(D0-,D1-,D2-,D3hot-,D3cold-) > Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- > Capabilities: [90] Express (v2) Endpoint, MSI 00 > DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s <64ns, > L1 <1us > ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset- > DevCtl: Report errors: Correctable- Non-Fatal+ Fatal+ > Unsupported+ > RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop- > MaxPayload 128 bytes, MaxReadReq 512 bytes > DevSta: CorrErr- UncorrErr- FatalErr- UnsuppReq- AuxPwr- > TransPend- > LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s, Latency > L0 unlimited, L1 <1us > ClockPM- Surprise- LLActRep- BwNot- > LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- Retrain- > CommClk+ > ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt- > LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+ > DLActive- BWMgmt- ABWMgmt- > DevCap2: Completion Timeout: Range A, TimeoutDis+ > DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis+ > LnkCtl2: Target Link Speed: 2.5GT/s, EnterCompliance- > SpeedDis-, Selectable De-emphasis: -6dB > Transmit Margin: Normal Operating Range, > EnterModifiedCompliance- ComplianceSOS- > Compliance De-emphasis: -6dB > LnkSta2: Current De-emphasis Level: -6dB > Capabilities: [100 v1] Vendor Specific Information: ID=0000 Rev=0 > Len=00c <?> > Kernel driver in use: DDBridge > Kernel modules: ddbridge > > Kernel 3.12.3 sees the device, but does not enable it. Only the ddbridge > driver is loaded, none of the tuner/demod drivers: > > root@mythtest:~# lsmod > Module Size Used by > ddbridge 17766 0 > > Nor, judging from dmesg output, is the firmware loaded: > [ 1.624996] Digital Devices PCIE bridge driver, Copyright (C) 2010-11 > Digital Devices GmbH > [ 1.652565] pci 0000:01:19.0: enabling device (0000 -> 0002) > [ 1.677601] DDBridge driver detected: Digital Devices PCIe bridge > [ 1.683598] HW ffffffff FW ffffffff > [ 2.160410] Adding 2097148k swap on /dev/sda3. Priority:-1 extents:1 > across:2097148k > [ 2.190386] Switched to clocksource tsc > > > What is the best kernel to have this dvb-card working? > Or, alternatively, the best combination of kernel version and out-of-kernel > stack?
I think the best out-of-kernel stack at the moment ist the one by Oliver Endriss. http://www.vdr-portal.de/board18-vdr-hardware/board102-dvb-karten/p1077194-#post1077194 I use it for my Cine C/T and it's working really good. Regards, Lars. > > > Thanks, > > > Rudy > > > > -- > To unsubscribe from this list: send the line "unsubscribe linux-media" in > the body of a message to [email protected] > More majordomo info at http://vger.kernel.org/majordomo-info.html > -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
