On 23 October 2014 13:57, Philipp Zabel <p.za...@pengutronix.de> wrote: > Hi Ulf, > > Am Montag, den 22.09.2014, 20:44 +0200 schrieb Ulf Hansson: >> On 22 September 2014 18:05, Philipp Zabel <p.za...@pengutronix.de> wrote: >> > From: Ulf Hansson <ulf.hans...@linaro.org> >> > >> > For several reasons it's good practice to leave devices in runtime PM >> > active state while those have been probed. >> > >> > In this cases we also want to prevent the device from going inactive, >> > until the firmware has been completely installed, especially when using >> > a PM domain. >> > >> > Signed-off-by: Ulf Hansson <ulf.hans...@linaro.org> >> > Signed-off-by: Philipp Zabel <p.za...@pengutronix.de> >> >> Thanks for moving this to the next version, I have been a bit busy the >> last week. >> >> Changes looking good! > > If I load the coda module on v3.18-rc1 with the GPC power domain patch > applied (at this point the power domain is disabled), the domain's > poweron callback is never called. It does work tough if I switch back to > explicitly calling pm_runtime_get_sync: > > diff --git a/drivers/media/platform/coda/coda-common.c > b/drivers/media/platform/coda/coda-common.c > index ac71e11..5421969 100644 > --- a/drivers/media/platform/coda/coda-common.c > +++ b/drivers/media/platform/coda/coda-common.c > @@ -2393,9 +2393,8 @@ static int coda_probe(struct platform_device *pdev) > * coda_fw_callback regardless of whether CONFIG_PM_RUNTIME is > * enabled or whether the device is associated with a PM domain. > */ > - pm_runtime_get_noresume(&pdev->dev); > - pm_runtime_set_active(&pdev->dev); > pm_runtime_enable(&pdev->dev); > + pm_runtime_get_sync(&pdev->dev); > > return coda_firmware_request(dev); > } > > At what point is the pm domain supposed to be enabled when I load the > module?
Hi Philipp, The PM domain shall be powered on prior your driver starts probing. This is a common problem when using the generic PM domain. The workaround, which is causing other issues, is a pm_runtime_get_sync(). Now, could you please try to apply the below patchset, that should hopefully fix your issue: [PATCH v3 0/9] PM / Domains: Fix race conditions during boot http://marc.info/?l=linux-pm&m=141320895122707&w=2 Kind regards Uffe -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
