The patch titled
     mmc: at91_mci: Enable MMC_CAP_SDIO_IRQ only when it actually works.
has been removed from the -mm tree.  Its filename was
     mmc-at91_mci-enable-mmc_cap_sdio_irq-only-when-it-actually-works.patch

This patch was dropped because it was merged into mainline or a subsystem tree

The current -mm tree may be found at http://userweb.kernel.org/~akpm/mmotm/

------------------------------------------------------
Subject: mmc: at91_mci: Enable MMC_CAP_SDIO_IRQ only when it actually works.
From: Nicolas Ferre <[email protected]>

According to the datasheets AT91SAM9261 does not support SDIO interrupts,
and AT91SAM9260/9263 have an erratum requiring 4bit mode while using slot
B for the interrupt to work.

Signed-off-by: Nicolas Ferre <[email protected]>
Cc: Wolfgang Muees <[email protected]>
Cc: Andrew Victor <[email protected]>
Cc: <[email protected]>
Signed-off-by: Andrew Morton <[email protected]>
---

 drivers/mmc/host/at91_mci.c |    9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff -puN 
drivers/mmc/host/at91_mci.c~mmc-at91_mci-enable-mmc_cap_sdio_irq-only-when-it-actually-works
 drivers/mmc/host/at91_mci.c
--- 
a/drivers/mmc/host/at91_mci.c~mmc-at91_mci-enable-mmc_cap_sdio_irq-only-when-it-actually-works
+++ a/drivers/mmc/host/at91_mci.c
@@ -929,7 +929,7 @@ static int __init at91_mci_probe(struct 
        mmc->f_min = 375000;
        mmc->f_max = 25000000;
        mmc->ocr_avail = MMC_VDD_32_33 | MMC_VDD_33_34;
-       mmc->caps = MMC_CAP_SDIO_IRQ;
+       mmc->caps = 0;
 
        mmc->max_blk_size  = MCI_MAXBLKSIZE;
        mmc->max_blk_count = MCI_BLKATONCE;
@@ -958,6 +958,13 @@ static int __init at91_mci_probe(struct 
                goto fail5;
        }
 
+       /* Add SDIO capability when available */
+       if (cpu_is_at91sam9260() || cpu_is_at91sam9263()) {
+               /* AT91SAM9260/9263 erratum */
+               if (host->board->wire4 || !host->board->slot_b)
+                       mmc->caps |= MMC_CAP_SDIO_IRQ;
+       }
+
        /*
         * Reserve GPIOs ... board init code makes sure these pins are set
         * up as GPIOs with the right direction (input, except for vcc)
_

Patches currently in -mm which might be from [email protected] are


--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to