From: Fabio Estevam <[email protected]>
Currently it is not possible to use 'mmc-pwrseq-simple' property with
this driver because mmc_pwrseq_alloc() is never called.
Call mmc_pwrseq_alloc so that we enable the support for providing a
reset GPIO to the Wifi/BT chipset.
Tested on a imx6sl-warp board:
root@imx6sl-warp:~# hciattach /dev/ttymxc1 3wire
Device setup complete
root@imx6sl-warp:~# hciconfig hci0 up
root@imx6sl-warp:~# hciconfig
hci0: Type: BR/EDR Bus: UART
BD Address: 2A:23:AA:6E:C7:A0 ACL MTU: 1021:8 SCO MTU: 64:1
UP RUNNING
RX bytes:795 acl:0 sco:0 events:29 errors:0
TX bytes:613 acl:0 sco:0 commands:29 errors:0
Signed-off-by: Fabio Estevam <[email protected]>
---
Changes since v1:
- Calling mmc_of_parse() breaks some boards due to bad card detect parsing.
Call only mmc_pwrseq_alloc() instead, which what we really need.
drivers/mmc/host/sdhci-esdhc-imx.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c
b/drivers/mmc/host/sdhci-esdhc-imx.c
index 7ee8312..5bcabdc 100644
--- a/drivers/mmc/host/sdhci-esdhc-imx.c
+++ b/drivers/mmc/host/sdhci-esdhc-imx.c
@@ -31,6 +31,8 @@
#include "sdhci-pltfm.h"
#include "sdhci-esdhc.h"
+#include "../core/pwrseq.h"
+
#define ESDHC_CTRL_D3CD 0x08
/* VENDOR SPEC register */
#define ESDHC_VENDOR_SPEC 0xc0
@@ -1079,6 +1081,10 @@ static int sdhci_esdhc_imx_probe(struct platform_device
*pdev)
host->quirks2 |= SDHCI_QUIRK2_NO_1_8_V;
}
+ err = mmc_pwrseq_alloc(host->mmc);
+ if (err)
+ goto disable_clk;
+
err = sdhci_add_host(host);
if (err)
goto disable_clk;
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
