Hello.
I have a dos program that controls some equipment via serial port.
The program uses direct UART's ports programming.
I couldn't get it work under dosemu. Com emulation via /dev/ttySx
very slow. I tried to allow direct port programming but it seems
didn't help.
I've got source code for this program. Is it possible to rewrite
port access procedures to get it faster ? Is there any DOS/BIOS
interrupts to control com ports that I can use ? Will it help ?
If so, point me please to docs on it.
wbw Andrey A. Kolesnik <crusoe at ukr dot net>
-
To unsubscribe from this list: send the line "unsubscribe linux-msdos" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
