I've been trying to set up dosemu on a clean system so that I can run the control software for some silicon processing equipment. This software uses two serial ports and also VGA graphics mode. I've already configured the serial ports and graphics in the conf file (com1 is /dev/ttyS0 and com2 is /dev/ttyS1, the video card is a trident 8900 unit). Here's the problems: A) None of the numbers are showing up on the screen. I can see most of the display just fine. But wherever there's supposed to be a number (i.e. 0-9) nothing shows. The letters show just fine. B) The software doesn't seem to be accessing the serial ports properly. I know linux is operating just fine because I've checked the ports through it. It's just not translating through dosemu. Any help would be appreciated. I'm trying desparately to get rid of the base Win95 system on the original controller computer and put this in its place. -Alexander Carver
