--
On Fri, 12 Nov 1999 16:03:38 Andre Sznajder wrote:
>Hi,
>I'm having a hard time trying to get a clipper program to run properly under
>dosemu. When I try to some files, I get a clipper error code 4 .
>In DOS this kind of problem is solved by using using a large number in for
>files=# in config.sys. I've tried the same procedure in dosemu but it doesn't
>help !
>Do you have any hints on what could be going on ?
>
>Thanks,
> Andre
I am running a Clipper Program in DOSEMU and it works fine. I have the following
lines in my CONFIG.SYS file
FILES=105
BUFFERS=50
Originally to get the Clipper applicaton running I had to set the dpmi in the
/etc/dosemu.conf file. In my /etc/dosemu.conf I have the dpmi set as follows:
$_dpmi = (1024)
Whether or not you have to set dpmi is dependent on how your Clipper Application was
compiled originally, but you can try it out to see if it works. I hope this helps,
since I am not sure what a clipper error code 4 is.
Regards,
GP Doyle
--== Sent via Deja.com http://www.deja.com/ ==--
Share what you know. Learn what you don't.
