Hello guys
I recently bought a SbLive!, so since the hardware settings changed
a lot i don't know how to put them correctly in the dosemu.conf file
As you know, sb16' s and similar most of the time use irq 5, base address
220 and dma 1. Since this card uses irq 10, base address E400 and no dma,
i dont' know what to put. In the dosemu.conf file, to use irq 5, it says
"0x220" , how can i put
E400 instead? (i don't know hexadecimal stuff)
I run dosemu using my win98 drive! So i dont need to make disk images
or stuff
I tried to use setup-hdimage before knowing how to use my win98 partition,
but that script is a mess. The programs to make it are listed at the wrong
dirs, something like dosemu/dexe/config-mtools, i had to change all that
, and when i tried to make the image from my floppy drive, it started to
copy all linux to the hdimage! It went nuts
I have version 0.99
Thanks
