I want to do the thing in the subject but i cannot... i've searched in
all docs that comes with dosemu,
and looking through dosemu-HOWTO i was about tou scream "EVRIKA" but
i've discovered
that there is no answer to the question:)
Please if there is anyone who can help me....
thanx, alex
This is caused by your VGA BIOS. I have found
that by enabling the IO port trace and seeing where it was clobbered.
Disable the "allowvideoportaccess on" line in
config and it will work fine. When you then have problems with the
video, try to enable more selective ranges of IO
addresses (e.g., 40-43).
4.6 How do I use dosemu over the serial ports?
4.7 How can I switch between dosemu and a shell
over the serial line?
John Taylor ([EMAIL PROTECTED]) reported
(94/5/25) that
I am running Linux 1.1.13 and want to point out a
great feature that should be protected and not taken out (IMHO). With
the 52 version, I can run the program,
"screen." From screen, i can invoke dos -D-a.
What is really great (IMHO) is the screen commands (the CTRL-A cmds)
still work. This means I can do a CTRL-A
C and add another unix shell, and switch between
the two (DOS / UNIX). This allows me to use dosemu over the serial line
really well, because switching is made
easy.
4.8 How can I get the parallel ports to work?
The dosemu.conf has lines at the end to redirect
printers to either lpr or a file. If you want direct access to the bare
metal, comment out these emulation lines, and add
the line
$_ports { device /dev/lp0 fast range 0x3bc
0x3bf } # lpt0
for the "monitor card" printer port (corresponds
to /dev/lp0), or
