If you have isapnptools installed you must use that to configure the card.
The tools are to programs, pnpdump and isapnp. Use pnpdump > pnp.conf to
create a config file for the card and edit this file to uncomment the
relevant IRQ/IO resources. Then you would run isapnp pnp.conf to set up the
card if all goes well (check using setserial) then add the necessary
command (isapnp pnp.conf, with correct path of course) to /etc/rc.local
(slackware) to have it come up on every boot. You will also have to add a
line to set the correct parameters for the new com port i.e. setserial
/dev/ttyS2 irq 5 uart 16550a spd_vhi for COM3 under dos using IRQ 5 and set
to allow 115200BPS communication.
At 04:36 AM 1/3/99 -0800, Taeyong Noh wrote:
>hi all,
>happy new year to all,
>I have attempted to install RD 5.2 to my system all went fine until
>I tried to get minicom to work, the system came back and told me that
>/dev/modem does not exist, I have a 56K rockwell plug-n-play modem, now
>I know the plug-n-play may have something to do with the modem not being
>regonized, any help would be greatly appricated,
>I have to reinstall win95 (god help me, just soo I could post this)
>Tay
>
>
