On Thu, 10 Feb 2000, Barry Carroll wrote:
> Hi all,
>
> This is my first post. I have tried to read all the HOWTO's and I just
> cannot mount my Zip drive!. It is the Primary slave on my IDE controller.
> I am using Caldera, latest version(?). I have even rebuilt the Kernel with
> atapi floppy support, but to no avail.
>
> I would be really thrilled if I could find out how to do this!
Juging by the HOWTO it should be no different than mounting any IDE
disk.
The HOWTO says for IDE devices NO extra kernel support is needed, so
there is no need to recompile your kernel, normaly speaking all
drivers are included in the standard distribution install.
Depending what filesystem is on the device.
mkdir /zip
edit /etc/fstab add a line like;
/dev/hdb1 /zip ext2 noauto 0 0
mount /dev/hdb1
Should do the trick, providing you have an ext2 filesystem on the
drive (according to the HOWTO), note the drive will not be ounted at
bootime, for that replace "noauto" with defaults in /etc/fstab.
Note2, i dont have one of these devices, i am quoting the HOWTO.
> Thanks,
>
> Barry.
--
Regards Richard
[EMAIL PROTECTED]
http://people.zeelandnet.nl/pa3gcu/
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.linux-learn.org/faqs
