On Thu, 03 Aug 2000, Jim Reimer wrote about, install problem - RH6.2:
> Got as far as "Performing post install configuration..." and then
> "install exited abnormally -- received signal 11". This was followed
> by fairly normally shutdown messages, "sending kill signals",
> "disabling swap", and so on, down to "you may safely reboot your system".
>
> Somebody tell me what's going on? First install attempt did the same
> thing, but earlier in the install process.
This paragraph suggests you have an overclocked CPU, check your motherboard
jumper settings and make sure they are set correctly.
Or it could be you have a bad memory chip.
http://bitwizard.nl/sig11
>
> Installed RH6.0 yesterday with no problem. Trying to get 6.2 on today.
Every new distro is more demanding than its predessor and demands more and
more from your computer.
>
> -jdr-
--
Regards Richard
[EMAIL PROTECTED]
http://people.zeelandnet.nl/pa3gcu/
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.linux-learn.org/faqs
