* Francisco Alecrim <[EMAIL PROTECTED]> [080401 05:29]:
> Acked-by : Francisco Alecrim <[EMAIL PROTECTED]>
>
> ext Seth Forshee wrote:
>> OMAP2430/3430 contain an 1.8V-only MMC2 host that is not properly
>> supported by the current driver. This patch contains changes to
>> correctly set up this host.
Pushing today.
Tony
>> Signed-off-by: Seth Forshee <[EMAIL PROTECTED]>
>> Acked-by: Francisco Alecrim <[EMAIL PROTECTED]>
>> ---
>> drivers/mmc/host/omap_hsmmc.c | 32 ++++++++++++++++++++++++++------
>> 1 files changed, 26 insertions(+), 6 deletions(-)
>>
>> diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
>> index 248257f..d5d82a8 100644
>> --- a/drivers/mmc/host/omap_hsmmc.c
>> +++ b/drivers/mmc/host/omap_hsmmc.c
>> @@ -388,8 +388,12 @@ static int omap_mmc_switch_opcond(struct mmc_omap_host
>> *host, int vdd)
>> * If a MMC dual voltage card is detected, the set_ios fn calls
>> * this fn with VDD bit set for 1.8V. Upon card removal from the
>> * slot, mmc_omap_detect fn sets the VDD back to 3V.
>> + *
>> + * Only MMC1 supports 3.0V. MMC2 will not function if SDVS30 is
>> + * set in HCTL.
>> */
>> - if (((1 << vdd) == MMC_VDD_32_33) || ((1 << vdd) == MMC_VDD_33_34))
>> + if (host->id == OMAP_MMC1_DEVID && (((1 << vdd) == MMC_VDD_32_33) ||
>> + ((1 << vdd) == MMC_VDD_33_34)))
>> reg_val |= SDVS30;
>> if ((1 << vdd) == MMC_VDD_165_195)
>> reg_val |= SDVS18;
>> @@ -517,10 +521,16 @@ mmc_omap_start_dma_transfer(struct mmc_omap_host
>> *host, struct mmc_request *req)
>> if (!(data->flags & MMC_DATA_WRITE)) {
>> host->dma_dir = DMA_FROM_DEVICE;
>> - sync_dev = OMAP24XX_DMA_MMC1_RX;
>> + if (host->id == OMAP_MMC1_DEVID)
>> + sync_dev = OMAP24XX_DMA_MMC1_RX;
>> + else
>> + sync_dev = OMAP24XX_DMA_MMC2_RX;
>> } else {
>> host->dma_dir = DMA_TO_DEVICE;
>> - sync_dev = OMAP24XX_DMA_MMC1_TX;
>> + if (host->id == OMAP_MMC1_DEVID)
>> + sync_dev = OMAP24XX_DMA_MMC1_TX;
>> + else
>> + sync_dev = OMAP24XX_DMA_MMC2_TX;
>> }
>> ret = omap_request_dma(sync_dev, "MMC/SD", mmc_omap_dma_cb,
>> @@ -692,6 +702,7 @@ static int __init omap_mmc_probe(struct platform_device
>> *pdev)
>> struct mmc_omap_host *host = NULL;
>> struct resource *res;
>> int ret = 0, irq;
>> + u32 hctl, capa;
>> if (pdata == NULL) {
>> dev_err(&pdev->dev, "Platform Data is missing\n");
>> @@ -778,11 +789,20 @@ static int __init omap_mmc_probe(struct
>> platform_device *pdev)
>> if (pdata->conf.wire4)
>> mmc->caps |= MMC_CAP_4_BIT_DATA;
>> + /* Only MMC1 supports 3.0V */
>> + if (host->id == OMAP_MMC1_DEVID) {
>> + hctl = SDVS30;
>> + capa = VS30 | VS18;
>> + } else {
>> + hctl = SDVS18;
>> + capa = VS18;
>> + }
>> +
>> OMAP_HSMMC_WRITE(host->base, HCTL,
>> - OMAP_HSMMC_READ(host->base, HCTL) | SDVS30);
>> + OMAP_HSMMC_READ(host->base, HCTL) | hctl);
>> - OMAP_HSMMC_WRITE(host->base, CAPA, OMAP_HSMMC_READ(host->base,
>> - CAPA) | VS30 | VS18);
>> + OMAP_HSMMC_WRITE(host->base, CAPA,
>> + OMAP_HSMMC_READ(host->base, CAPA) | capa);
>> /* Set the controller to AUTO IDLE mode */
>> OMAP_HSMMC_WRITE(host->base, SYSCONFIG,
>>
>
>
> --
> Francisco Keppler Silva Alecrim - INdT
> Phone: +55 92 2126-1017
> Mobile: +55 92 9152-7000
>
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
