Removing unnecessary '#ifdef' in 'nand/omap2.c' and changing hwecc config
option from 'int' to 'bool' in 'nand/Kconfig'.
Because of 'int' option hw ecc was always used even if sw ecc had been selected.
Signed-off-by: Vimal Singh <[EMAIL PROTECTED]>
---
drivers/mtd/nand/Kconfig | 6 ++----
drivers/mtd/nand/omap2.c | 4 ----
2 files changed, 2 insertions(+), 8 deletions(-)
Index: omapkernel/drivers/mtd/nand/Kconfig
===================================================================
--- omapkernel.orig/drivers/mtd/nand/Kconfig 2008-10-24 11:24:52.000000000
+0530
+++ omapkernel/drivers/mtd/nand/Kconfig 2008-10-29 15:57:03.000000000 +0530
@@ -75,14 +75,12 @@
Support for NAND flash on Texas Instruments OMAP2 and OMAP3
platforms.
config MTD_NAND_OMAP_HWECC
- int "The ECC computation logic (0 = software ecc, 1 = hardware ecc)"
+ bool "The ECC computation logic (y = hardware ecc, n = software ecc)"
depends on MTD_NAND && MTD_NAND_OMAP2
- default "0"
+ default y
help
The ECC compuatation for the data to be written/read can be either
by
software or omap has Hw ecc engine which calculates it.
- MTD_NAND_OMAP_HWECC = 1 which enables the hw ecc
- MTD_NAND_OMAP_HWECC = 0, enables software ecc
config MTD_NAND_OMAP
tristate "NAND Flash device on OMAP H3/H2/P2 boards"
Index: omapkernel/drivers/mtd/nand/omap2.c
===================================================================
--- omapkernel.orig/drivers/mtd/nand/omap2.c 2008-10-24 11:24:52.000000000
+0530
+++ omapkernel/drivers/mtd/nand/omap2.c 2008-10-29 16:19:48.000000000 +0530
@@ -111,10 +111,6 @@
static const char *part_probes[] = { "cmdlinepart", NULL };
#endif
-#ifndef MTD_NAND_OMAP_HWECC
-#define MTD_NAND_OMAP_HWECC 0
-#endif
-
struct omap_nand_info {
struct nand_hw_control controller;
struct omap_nand_platform_data *pdata;
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
