* Grazvydas Ignotas <[EMAIL PROTECTED]> [081113 13:40]:
> Some boards use input clock from external pin for MMC/SDIO
> modules in OMAP chips. Make that option selectable instead of
> forcing loop back clock on everyone.
Thanks, pushing both today.
Tony
> Signed-off-by: Grazvydas Ignotas <[EMAIL PROTECTED]>
> ---
> This patch applies on previous patch I sent:
> "minor mmc-twl4030 cleanups"
>
> arch/arm/mach-omap2/mmc-twl4030.c | 14 ++++++++------
> arch/arm/mach-omap2/mmc-twl4030.h | 1 +
> 2 files changed, 9 insertions(+), 6 deletions(-)
>
> diff --git a/arch/arm/mach-omap2/mmc-twl4030.c
> b/arch/arm/mach-omap2/mmc-twl4030.c
> index b1fe0f3..0ea6ba6 100644
> --- a/arch/arm/mach-omap2/mmc-twl4030.c
> +++ b/arch/arm/mach-omap2/mmc-twl4030.c
> @@ -250,8 +250,7 @@ static int twl_mmc1_set_power(struct device *dev, int
> slot, int power_on,
> omap_ctrl_writel(reg, OMAP243X_CONTROL_DEVCONF1);
> }
>
> - /* REVISIT: Loop back clock not needed for 2430? */
> - if (!cpu_is_omap2430()) {
> + if (c->mmc->slots[0].internal_clock) {
> reg = omap_ctrl_readl(OMAP2_CONTROL_DEVCONF0);
> reg |= OMAP2_MMCSDIO1ADPCLKISEL;
> omap_ctrl_writel(reg, OMAP2_CONTROL_DEVCONF0);
> @@ -298,11 +297,13 @@ static int twl_mmc2_set_power(struct device *dev, int
> slot, int power_on, int vd
> struct twl_mmc_controller *c = &hsmmc[1];
>
> if (power_on) {
> - u32 reg;
> + if (c->mmc->slots[0].internal_clock) {
> + u32 reg;
>
> - reg = omap_ctrl_readl(control_devconf1_offset);
> - reg |= OMAP2_MMCSDIO2ADPCLKISEL;
> - omap_ctrl_writel(reg, control_devconf1_offset);
> + reg = omap_ctrl_readl(control_devconf1_offset);
> + reg |= OMAP2_MMCSDIO2ADPCLKISEL;
> + omap_ctrl_writel(reg, control_devconf1_offset);
> + }
> ret = twl_mmc_set_voltage(c, vdd);
> } else {
> ret = twl_mmc_set_voltage(c, 0);
> @@ -354,6 +355,7 @@ void __init hsmmc_init(struct twl4030_hsmmc_info
> *controllers)
> MMC_VDD_29_30 |
> MMC_VDD_30_31 | MMC_VDD_31_32;
> mmc->slots[0].wires = c->wires;
> + mmc->slots[0].internal_clock = !c->ext_clock;
> mmc->dma_mask = 0xffffffff;
>
> /* note: twl4030 card detect GPIOs normally switch VMMCx ... */
> diff --git a/arch/arm/mach-omap2/mmc-twl4030.h
> b/arch/arm/mach-omap2/mmc-twl4030.h
> index a2e60fe..e2d58a2 100644
> --- a/arch/arm/mach-omap2/mmc-twl4030.h
> +++ b/arch/arm/mach-omap2/mmc-twl4030.h
> @@ -11,6 +11,7 @@ struct twl4030_hsmmc_info {
> u8 wires; /* 1/4/8 wires */
> int gpio_cd; /* or -EINVAL */
> int gpio_wp; /* or -EINVAL */
> + int ext_clock:1; /* use external pin for input clock */
> };
>
> #if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE) || \
> --
> 1.5.4.3
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to [EMAIL PROTECTED]
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
