On Tue, Nov 18, 2014 at 07:31:44PM +0300, Alexander Kochetkov wrote: > > > Still, as of now we can't consider what Alexander mentions a bug. Good > > to get it sorted out, but not -rc material. > > > > Actually, I focused on fixing issues then i2c-omap acts as master in a > multi master environment.
but that's not supported either. If you wanna do that, then go through
the TRM and implement what's missing. Then give a good commit log
explaining the issues and how you solved them :-)
Still not -rc material :-)
> And must say, that current linux/mainline driver work perfectly with
> minor fixes.
that's good to know. I know some folks still have a few hick ups. The IP
isn't all that great, I'm afraid.
> I could take a look how to switch the driver into mixed master/slave
> mode, but later.
>
> Sad to say, I encountered undocumented i2c- hardware issue.
> In short: BB-bit doesn't reflect I2C-bus state after soft reset if SDA
> or SCL line was low during reset until i2c-controller again detect
> START or STOP condition on the wire.
this is another of those which really deserves a mention in code comment
or commit log :-)
> More over, if SDA was low during reset, than next submitted transfer
> will not start ("controller timeout"), if SCL was low during reset,
> than next submitted transfer will start and corrupt signals on wire :(
another thing to add as comment to code :-)
> I'm checking it now. And going to post results to ti forum.
>
> BB-bit reflect I2C-bus state, between power-down/power-up modes.
alright, thanks.
--
balbi
signature.asc
Description: Digital signature
