On 03/16/2015 12:40 PM, Peter Ujfalusi wrote:
Hi,
This series will fix the following error during boot (both DT and legacy boot):
[ 0.307739] omap_hwmod: mcbsp2: _wait_target_ready failed: -16
[ 0.307769] omap_hwmod: mcbsp2: cannot be enabled for reset (3)
The clock definitions/aliases for McBSP ports were not correct.
In case of DT boot we still have the following warning printed from hwmod:
[ 0.222900] omap_hwmod: mcbsp2_sidetone using broken dt data from mcbsp
[ 0.225311] omap_hwmod: mcbsp3_sidetone using broken dt data from mcbsp
These are there because mcbsp is using two hwmods in the DT and hwmod prints
out a warning for these. In legacy mode we also have 2 hwmods for McBSP2/3.
One for the McBSP itself and the other for the sidetone block attached to them.
I'll try to look into this one next.
Since this series fixes the _wait_target_ready issue, can this be sent for 4.0?
I don't think this is a critical fix, the wait_target_ready issue has
been around for ages. Queued for 4.1 though, thanks.
-Tero
Regards,
Peter
---
Peter Ujfalusi (2):
clk: ti: clk-3xxx: Correct McBSP related DT clock definitions
clk: ti: clk-3xxx-legacy: Correct McBSP related clock aliases
drivers/clk/ti/clk-3xxx-legacy.c | 16 +++++++++-------
drivers/clk/ti/clk-3xxx.c | 19 +++++++------------
2 files changed, 16 insertions(+), 19 deletions(-)
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html