On Tue, Jul 14, 2015 at 02:29:46PM -0500, Franklin S Cooper Jr wrote:
> From: Roger Quadros <rog...@ti.com>
>
> Update driver to support without regulators.
>
> Without this patch boards that do not enable regulator config options will
> fail to boot with a kernel panic.
>
> Signed-off-by: Roger Quadros <rog...@ti.com>
> Signed-off-by: Lokesh Vutla <lokeshvu...@ti.com>
> Signed-off-by: Murali Karicheri <m-kariche...@ti.com>
> Signed-off-by: Franklin S Cooper Jr <fcoo...@ti.com>
> ---
> Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt | 2 ++
> drivers/mmc/host/omap_hsmmc.c | 14 ++++++++++----
> 2 files changed, 12 insertions(+), 4 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
> b/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
> index 76bf087..2408e87 100644
> --- a/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
> +++ b/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
> @@ -22,6 +22,8 @@ ti,dual-volt: boolean, supports dual voltage cards
> ti,non-removable: non-removable slot (like eMMC)
> ti,needs-special-reset: Requires a special softreset sequence
> ti,needs-special-hs-handling: HSMMC IP needs special setting for handling
> High Speed
> +voltage-ranges: Specify the voltage range supported if regulator framework
> +isn't enabled.
> dmas: List of DMA specifiers with the controller specific format
> as described in the generic DMA client binding. A tx and rx
> specifier is required.
> diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
> index b2b411d..16c870f 100644
> --- a/drivers/mmc/host/omap_hsmmc.c
> +++ b/drivers/mmc/host/omap_hsmmc.c
> @@ -1551,10 +1551,13 @@ static void omap_hsmmc_set_ios(struct mmc_host *mmc,
> struct mmc_ios *ios)
> if (ios->power_mode != host->power_mode) {
> switch (ios->power_mode) {
> case MMC_POWER_OFF:
> - mmc_pdata(host)->set_power(host->dev, 0, 0);
> + if (host->use_reg)
> + mmc_pdata(host)->set_power(host->dev, 0, 0);looks like this driver should just be use regulator_get_optional(), then ->set_power() would still work, no ? -- balbi
signature.asc
Description: Digital signature
