Most register values for the chip select setup depend on the frequency
of the fck clock.
So add a hint that the values setup by the bootloader might differ from
the right setup for Linux if the bootloader uses a different frequency.
Signed-off-by: Uwe Kleine-König <u.kleine-koe...@pengutronix.de>
---
drivers/memory/Kconfig | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/memory/Kconfig b/drivers/memory/Kconfig
index c6a644b22af4..1414dd53be57 100644
--- a/drivers/memory/Kconfig
+++ b/drivers/memory/Kconfig
@@ -64,6 +64,9 @@ config OMAP_GPMC_DEBUG
Enables verbose debugging mostly to decode the bootloader provided
timings. Enable this during development to configure devices
connected to the GPMC bus.
+ Note that you cannot just tweak your device tree until the registers
+ setup by linux match what the bootloader did because that one might
+ use a different fck frequency influencing most register settings.
config MVEBU_DEVBUS
bool "Marvell EBU Device Bus Controller"
--
2.6.0
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
