Hi, I'm just working on a new, updated version of ams_delta_defconfig. Starting from the current version, created over 2 years ago for 2.6.22, I turned on a few device drivers that was added recently, turned on thumb instructions support, turned on EABI, kept old ABI compatibility and NWFPE, and got a resulting kernel that is ~170kB too large to be successfully booted using tools available at http://the.earth.li/pub/e3/.
Of course, I am able to trim that down, even adding a few more drivers for add-on hardware that I am using, and get a kernel that works perfectly for me, but since I have never prepared a default config, I'd like to get your advice on what I can remove and what should rather be kept untouched. Instead of pasting sixteen hundred lines here, I'd rather ask about the simplest change I can see: -# CONFIG_EMBEDDED is not set -CONFIG_KALLSYMS=y +CONFIG_EMBEDDED=y +# CONFIG_KALLSYMS is not set That would give me a kernel that is small enough, but since only a few of arm defconfigs have CONFIG_KALLSYMS not set, I am not sure if it is generally acceptable. Thanks, Janusz -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
