Hi Dirk,
Dirk Behme wrote:
> On 21.12.2009 17:46, Mike Rapoport wrote:
>> Hi,
>>
>> Phaneendra Kumar Alapati wrote:
>>> This patch adds SDIO IRQ support for OMAP35xx. Tested on OMAP3530EVM
>>> with Marvell 88W8686 card and below are the observed throughput results
>>> (ttcp utility): 13Mbps (Downlink), 10.5 Mbps(Uplink)
>>>
>>> Signed-off-by: Phaneendra Kumar<[email protected]>
>>> ---
>>> drivers/mmc/host/omap_hsmmc.c | 55
>>> ++++++++++++++++++++++++++++++++++++----
>>> 1 files changed, 49 insertions(+), 6 deletions(-)
>>
>> I've tried the patch on CM-T35 that has Marvell 88W8686 on-board and
>> surprisingly I get a lot of command timeouts from the libertas driver :(
>> ---
>> libertas: requeueing command 0x0006 due to timeout (#1)
>> libertas: Received result 0 to command 6 after 1 retries
>> libertas: command 0x0006 timed out
>> ---
>> I hope I'll find time to debug it in the next few days and provide
>> more valuable
>> information...
>
> There is a test report from Overo air that there it doesn't work, too:
>
> http://old.nabble.com/Re%3A-Overo-wifi-speed-and-WPA2-connection-issue-p27231874.html
>
>
> Any news on this patch?
Unfortunately I haven't got time to see why libertas is unhappy with
this patch.. :(
> Best regards
>
> Dirk
>
>>> diff --git a/drivers/mmc/host/omap_hsmmc.c
>>> b/drivers/mmc/host/omap_hsmmc.c
>>> index 4b23225..fa94580 100644
>>> --- a/drivers/mmc/host/omap_hsmmc.c
>>> +++ b/drivers/mmc/host/omap_hsmmc.c
>>> @@ -100,6 +100,10 @@
>>> #define SRD (1<< 26)
>>> #define SOFTRESET (1<< 1)
>>> #define RESETDONE (1<< 0)
>>> +#define CIRQ (1<< 8)
>>> +#define CIRQ_ENABLE (1<< 8)
>>> +#define CTPL (1<< 11)
>>> +#define CLKEXTFREE (1<< 16)
>>>
>>> /*
>>> * FIXME: Most likely all the data using these _DEVID defines
>>> should come
>>> @@ -171,6 +175,7 @@ struct omap_hsmmc_host {
>>> int vdd;
>>> int protect_card;
>>> int reqs_blocked;
>>> + int sdio_int;
>>>
>>> struct omap_mmc_platform_data *pdata;
>>> };
>>> @@ -436,6 +441,13 @@ omap_hsmmc_start_command(struct omap_hsmmc_host
>>> *host, struct mmc_command *cmd,
>>> else
>>> OMAP_HSMMC_WRITE(host->base, IE, INT_EN_MASK);
>>>
>>> + if (host->sdio_int) {
>>> + OMAP_HSMMC_WRITE(host->base, ISE,
>>> + (OMAP_HSMMC_READ(host->base, ISE) | CIRQ_ENABLE));
>>> + OMAP_HSMMC_WRITE(host->base, IE,
>>> + (OMAP_HSMMC_READ(host->base, IE) | CIRQ_ENABLE));
>>> + }
>>> +
>>> host->response_busy = 0;
>>> if (cmd->flags& MMC_RSP_PRESENT) {
>>> if (cmd->flags& MMC_RSP_136)
>>> @@ -640,6 +652,17 @@ static irqreturn_t omap_hsmmc_irq(int irq, void
>>> *dev_id)
>>>
>>> spin_lock(&host->irq_lock);
>>>
>>> + data = host->data;
>>> + status = OMAP_HSMMC_READ(host->base, STAT);
>>> + dev_dbg(mmc_dev(host->mmc), "IRQ Status is %x\n", status);
>>> +
>>> + if (host->mmc->caps& MMC_CAP_SDIO_IRQ) {
>>> + if (status& CIRQ) {
>>> + dev_dbg(mmc_dev(host->mmc), "SDIO Card Interrupt\n");
>>> + mmc_signal_sdio_irq(host->mmc);
>>> + }
>>> + }
>>> +
>>> if (host->mrq == NULL) {
>>> OMAP_HSMMC_WRITE(host->base, STAT,
>>> OMAP_HSMMC_READ(host->base, STAT));
>>> @@ -649,10 +672,6 @@ static irqreturn_t omap_hsmmc_irq(int irq, void
>>> *dev_id)
>>> return IRQ_HANDLED;
>>> }
>>>
>>> - data = host->data;
>>> - status = OMAP_HSMMC_READ(host->base, STAT);
>>> - dev_dbg(mmc_dev(host->mmc), "IRQ Status is %x\n", status);
>>> -
>>> if (status& ERR) {
>>> #ifdef CONFIG_MMC_DEBUG
>>> omap_hsmmc_report_irq(host, status);
>>> @@ -1254,6 +1273,25 @@ static int omap_hsmmc_get_ro(struct mmc_host
>>> *mmc)
>>> return mmc_slot(host).get_ro(host->dev, 0);
>>> }
>>>
>>> +static void omap_hsmmc_enable_sdio_irq(struct mmc_host *mmc, int
>>> enable)
>>> +{
>>> + struct omap_hsmmc_host *host = mmc_priv(mmc);
>>> +
>>> + host->sdio_int = enable;
>>> + if (enable) {
>>> + OMAP_HSMMC_WRITE(host->base, ISE,
>>> + (OMAP_HSMMC_READ(host->base, ISE) | CIRQ_ENABLE));
>>> + OMAP_HSMMC_WRITE(host->base, IE,
>>> + (OMAP_HSMMC_READ(host->base, IE) | CIRQ_ENABLE));
>>> + } else {
>>> + OMAP_HSMMC_WRITE(host->base, IE,
>>> + (OMAP_HSMMC_READ(host->base, IE)& (~CIRQ_ENABLE)));
>>> + OMAP_HSMMC_WRITE(host->base, ISE,
>>> + (OMAP_HSMMC_READ(host->base, ISE)& (~CIRQ_ENABLE)));
>>> + }
>>> +
>>> +}
>>> +
>>> static void omap_hsmmc_conf_bus_power(struct omap_hsmmc_host *host)
>>> {
>>> u32 hctl, capa, value;
>>> @@ -1519,7 +1557,7 @@ static const struct mmc_host_ops omap_hsmmc_ops
>>> = {
>>> .set_ios = omap_hsmmc_set_ios,
>>> .get_cd = omap_hsmmc_get_cd,
>>> .get_ro = omap_hsmmc_get_ro,
>>> - /* NYET -- enable_sdio_irq */
>>> + .enable_sdio_irq = omap_hsmmc_enable_sdio_irq,
>>> };
>>>
>>> static const struct mmc_host_ops omap_hsmmc_ps_ops = {
>>> @@ -1529,7 +1567,7 @@ static const struct mmc_host_ops
>>> omap_hsmmc_ps_ops = {
>>> .set_ios = omap_hsmmc_set_ios,
>>> .get_cd = omap_hsmmc_get_cd,
>>> .get_ro = omap_hsmmc_get_ro,
>>> - /* NYET -- enable_sdio_irq */
>>> + .enable_sdio_irq = omap_hsmmc_enable_sdio_irq,
>>> };
>>>
>>> #ifdef CONFIG_DEBUG_FS
>>> @@ -1657,6 +1695,7 @@ static int __init omap_hsmmc_probe(struct
>>> platform_device *pdev)
>>> host->mapbase = res->start;
>>> host->base = ioremap(host->mapbase, SZ_4K);
>>> host->power_mode = -1;
>>> + host->sdio_int = 0;
>>>
>>> platform_set_drvdata(pdev, host);
>>> INIT_WORK(&host->mmc_carddetect_work, omap_hsmmc_detect);
>>> @@ -1744,6 +1783,10 @@ static int __init omap_hsmmc_probe(struct
>>> platform_device *pdev)
>>> if (mmc_slot(host).nonremovable)
>>> mmc->caps |= MMC_CAP_NONREMOVABLE;
>>>
>>> + mmc->caps |= MMC_CAP_SDIO_IRQ;
>>> + OMAP_HSMMC_WRITE(host->base, CON,
>>> + OMAP_HSMMC_READ(host->base, CON) | (CTPL | CLKEXTFREE));
>>> +
>>> omap_hsmmc_conf_bus_power(host);
>>>
>>> /* Select DMA lines */
>>
>
--
Sincerely yours,
Mike.
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
