Anand Gadiyar <gadiyar <at> ti.com> writes: > > Hi all,
Hi Anand, > > (Apologies if you get this twice - I sent this out 24 hours ago, > and it still hasn't reached the lists. So resending). > > This patch series adds the bus glue layer for the OHCI controller > on OMAP3 and later chips. This controller is a companion > to the EHCI controller on that IP, and some code is common > across the drivers. The driver has been sitting in internal > trees for ages, and I've finally found time to clean it up > and submit it. This is a good news, one or two month ago we were looking for such a patch! Finally we take an old version that we adapt to just make it works. Our future plan was to clean it up and submit a correct version. As your version seems more advanced,we will take it and test it for our board. I hope be able to feed information by the end of the week. > The older OMAP1 and OMAP2 chips had a different OHCI controller, > which already has driver support in mainline. I don't have access > to this and haven't tested the driver on those boards. > (Also, I made some updates to Kconfig, and have not yet updated the > defconfigs for those omap1/2 boards. I'll update them if the Kconfig > changes are okay) > > This controller supports multiple interface modes. Only 2 of them > (3-pin DAT/SE0 and 4-pin DP/DM PHY modes) have been tested with this > driver. (However the only change for the other modes is one register > setting for selecting the mode, and the padconf setting for the omap > pads), so I expect it to work correctly with this version. > > If anyone has OMAP3 boards with an OHCI controller, please test. Our board use the 6-pin DP/DM PHY mode, so it will be a new mode to be validated > > Thanks, > Anand -- Gregory CLEMENT Embedded Linux Development Lead - EMEA Adeneo Embedded - Adetel Group -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
