Tony Lindgren <[email protected]> writes: > * Kevin Hilman <[email protected]> [100430 13:50]: >> Tony Lindgren <[email protected]> writes: >> >> > Zoom2 and 3 have UARTs only on the external debug board. >> > GPMC needs to be mapped early to use it for DEBUG_LL. >> > >> > Additionally, 0xfb000000 overlaps with other areas, so >> > use 0xfa400000 for the virtual address instead. >> > >> > Note that with the pending serial.c patches you need to >> > set console=ttyS0,115200n8 as it will be the only UART >> > mapped. To use DEBUG_LL, you need to pass also earlyprintk >> > in cmdline. >> > >> > Cc: Allen Pais <[email protected]> >> > Cc: Vikram Pandita <[email protected]> >> > Signed-off-by: Tony Lindgren <[email protected]> >> > --- >> > arch/arm/kernel/head.S | 10 ++++++++++ >> > arch/arm/mach-omap2/board-zoom-debugboard.c | 2 +- >> > arch/arm/mach-omap2/include/mach/debug-macro.S | 4 ++-- >> > arch/arm/mach-omap2/io.c | 9 +++++++++ >> > arch/arm/plat-omap/include/plat/serial.h | 2 +- >> > 5 files changed, 23 insertions(+), 4 deletions(-) >> > >> > diff --git a/arch/arm/kernel/head.S b/arch/arm/kernel/head.S >> > index eb62bf9..fd870e1 100644 >> > --- a/arch/arm/kernel/head.S >> > +++ b/arch/arm/kernel/head.S >> > @@ -328,6 +328,16 @@ __create_page_tables: >> > add r0, r4, #0xd8000000 >> 18 >> > str r3, [r0] >> > #endif >> > +#if defined(CONFIG_MACH_OMAP_ZOOM2) || defined(CONFIG_MACH_OMAP_ZOOM3) >> > + /* >> > + * Zoom2 and Zoom3 have UARTs only on the debug board. >> > + * The debug board is connected to the GPMC. >> > + */ >> > + add r0, r4, #0xfa000000 >> 18 >> > + orr r0, r0, #0x00400000 >> 18 @ ZOOM_UART_VIRT >> > + orr r3, r7, #0x10000000 @ ZOOM_UART_BASE >> > + str r3, [r0] >> > +#endif >> >> I don't see why this part is needed. The same mapping is done using >> the .io_pg_offset in the machine description which is done just before >> this in head.S > > That mapping does not cover the GPMC area where this UART is.
Hmm, then shouldn't that be fixed? I understood the .phys_io and and .io_pg_offset fields of the mach_desc to be specifically for mapping the early UART, and nothing else. Kevin -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
