MMC controller Reset is handled in hwmod framework and thus remove MMC controller reset which is done seperately.
Cc: Kevin Hilman <[email protected]> Cc: Benoit Cousson <[email protected]> Signed-off-by: Kishore Kadiyala <[email protected]> --- arch/arm/mach-omap2/devices.c | 104 +---------------------------------------- 1 files changed, 1 insertions(+), 103 deletions(-) diff --git a/arch/arm/mach-omap2/devices.c b/arch/arm/mach-omap2/devices.c index 5b0e171..77b979b 100644 --- a/arch/arm/mach-omap2/devices.c +++ b/arch/arm/mach-omap2/devices.c @@ -12,6 +12,7 @@ #include <linux/module.h> #include <linux/kernel.h> #include <linux/init.h> +#include <linux/err.h> #include <linux/platform_device.h> #include <linux/io.h> #include <linux/clk.h> @@ -503,108 +504,6 @@ static inline void omap_init_sham(void) { } /*-------------------------------------------------------------------------*/ -#if defined(CONFIG_ARCH_OMAP3) || defined(CONFIG_ARCH_OMAP4) - -#define MMCHS_SYSCONFIG 0x0010 -#define MMCHS_SYSCONFIG_SWRESET (1 << 1) -#define MMCHS_SYSSTATUS 0x0014 -#define MMCHS_SYSSTATUS_RESETDONE (1 << 0) - -static struct platform_device dummy_pdev = { - .dev = { - .bus = &platform_bus_type, - }, -}; - -/** - * omap_hsmmc_reset() - Full reset of each HS-MMC controller - * - * Ensure that each MMC controller is fully reset. Controllers - * left in an unknown state (by bootloader) may prevent retention - * or OFF-mode. This is especially important in cases where the - * MMC driver is not enabled, _or_ built as a module. - * - * In order for reset to work, interface, functional and debounce - * clocks must be enabled. The debounce clock comes from func_32k_clk - * and is not under SW control, so we only enable i- and f-clocks. - **/ -static void __init omap_hsmmc_reset(void) -{ - u32 i, nr_controllers; - - if (cpu_is_omap242x()) - return; - - nr_controllers = cpu_is_omap44xx() ? OMAP44XX_NR_MMC : - (cpu_is_omap34xx() ? OMAP34XX_NR_MMC : OMAP24XX_NR_MMC); - - for (i = 0; i < nr_controllers; i++) { - u32 v, base = 0; - struct clk *iclk, *fclk; - struct device *dev = &dummy_pdev.dev; - - switch (i) { - case 0: - base = OMAP2_MMC1_BASE; - break; - case 1: - base = OMAP2_MMC2_BASE; - break; - case 2: - base = OMAP3_MMC3_BASE; - break; - case 3: - if (!cpu_is_omap44xx()) - return; - base = OMAP4_MMC4_BASE; - break; - case 4: - if (!cpu_is_omap44xx()) - return; - base = OMAP4_MMC5_BASE; - break; - } - - if (cpu_is_omap44xx()) - base += OMAP4_MMC_REG_OFFSET; - - dummy_pdev.id = i; - dev_set_name(&dummy_pdev.dev, "mmci-omap-hs.%d", i); - iclk = clk_get(dev, "ick"); - if (iclk && clk_enable(iclk)) - iclk = NULL; - - fclk = clk_get(dev, "fck"); - if (fclk && clk_enable(fclk)) - fclk = NULL; - - if (!iclk || !fclk) { - printk(KERN_WARNING - "%s: Unable to enable clocks for MMC%d, " - "cannot reset.\n", __func__, i); - break; - } - - omap_writel(MMCHS_SYSCONFIG_SWRESET, base + MMCHS_SYSCONFIG); - v = omap_readl(base + MMCHS_SYSSTATUS); - while (!(omap_readl(base + MMCHS_SYSSTATUS) & - MMCHS_SYSSTATUS_RESETDONE)) - cpu_relax(); - - if (fclk) { - clk_disable(fclk); - clk_put(fclk); - } - if (iclk) { - clk_disable(iclk); - clk_put(iclk); - } - } -} -#else -static inline void omap_hsmmc_reset(void) {} -#endif - #if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE) || \ defined(CONFIG_MMC_OMAP_HS) || defined(CONFIG_MMC_OMAP_HS_MODULE) @@ -852,7 +751,6 @@ static int __init omap2_init_devices(void) /* please keep these calls, and their implementations above, * in alphabetical order so they're easier to sort through. */ - omap_hsmmc_reset(); omap_init_camera(); omap_init_mbox(); omap_init_mcspi(); -- 1.7.0.4 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
