Cyril Chemparathy <[email protected]> writes: > Davinci's EMAC device has an in-built MDIO controller and a CPDMA engine. > These hardware modules are not restricted to EMAC device alone. For example, > CPSW3G (3-port gigabit ethernet switch) hardware uses these very same modules > internally. This patch series separates out EMAC's MDIO and CPDMA > functionality, allowing these individual pieces to be reused across TI > hardware.
[...] > Changes from v3 (rolled in "post cpdma/mdio refactoring fixes" series): > 1. allow forced 100/full mode instead of phy auto-detect > 2. specify phy_id on boards that had a phy_mask defined earlier > 3. requeue cpdma descriptors when EOQ at submit > 4. use calculated mdio bus access times instead of hardcoded delays > 5. work around emac soft-reset impact on mdio controller state > 6. extend register dumps to include cpdma registers > 7. updated sign offs and acks Thanks Cyril for one more spin with these updates. Queuing this one for 2.6.37 in davinci-next. davinci git is now updated with this series (may take a bit to propagate to kernel.org mirrors though) Kevin -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
