From: Koen Kooi <[email protected]> GPIO reset line for Beagle XM is different from vanilla beagle so we populate it as part of gpio update routine.
This in part fixes the issue of display not functioning on beagle XM platform. [[email protected]: split up, added descriptive changelogs] Signed-off-by: Nishanth Menon <[email protected]> Signed-off-by: Koen Kooi <[email protected]> --- arch/arm/mach-omap2/board-omap3beagle.c | 8 +++++++- 1 files changed, 7 insertions(+), 1 deletions(-) diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c index 1b5aa7a..d628f5e 100644 --- a/arch/arm/mach-omap2/board-omap3beagle.c +++ b/arch/arm/mach-omap2/board-omap3beagle.c @@ -199,7 +199,7 @@ static struct omap_dss_device beagle_dvi_device = { .name = "dvi", .driver_name = "generic_panel", .phy.dpi.data_lines = 24, - .reset_gpio = 170, + .reset_gpio = -EINVAL, .platform_enable = beagle_enable_dvi, .platform_disable = beagle_disable_dvi, }; @@ -308,6 +308,12 @@ static int beagle_twl_gpio_setup(struct device *dev, else gpio_direction_output(gpio + TWL4030_GPIO_MAX, 0); + /* DVI reset GPIO is different between beagle revisions */ + if (omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_XM) + beagle_dvi_device.reset_gpio = 129; + else + beagle_dvi_device.reset_gpio = 170; + /* TWL4030_GPIO_MAX + 1 == ledB, PMU_STAT (out, active low LED) */ gpio_leds[2].gpio = gpio + TWL4030_GPIO_MAX + 1; -- 1.6.3.3 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
