On Fri, Feb 11, 2011 at 4:38 PM, Koen Kooi <[email protected]> wrote: >> I fetched this branch which contains 35 patches on top of 2.6.38-rc4. >> After fixing some conflict, I applied these 35 patches on our Ubuntu >> ti-omap-dev kernel. With built-in the DSS2 driver and GENERIC_DPI >> driver, kernel boots fine on my Panda with Ubuntu GUI. But I have to >> set the kernel boot command args with omapfb.mode=dvi:1024x768MR-24@60 >> omapdss.def_disp=dvi, pointed out by Sebastien. Without this bootargs, >> no graphic at all. so as Robert concerned, EDID detection doesn't >> work. Does that related to I2C driver? I2C driver always tell me >> timeout in dmesg. > > AIUI the i2c bus is only hooked up to the HDMI port, so unless you plug in > something there, no dice.
Are you sure? According to the pandaboard user manual, there seem to be an i2c connection (i2c3): page 31, fig 9: http://pandaboard.org/sites/default/files/board_reference/A1/Panda_Board_Spec_DOC-21010_REV0_6.pdf -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
