> > > [ 0.208892] omap_hwmod: i2c1: softreset failed (waited 10000 usec)
> > > [ 0.223114] omap_hwmod: i2c2: softreset failed (waited 10000 usec)
> > > [ 0.237335] omap_hwmod: i2c3: softreset failed (waited 10000 usec)
> > > [ 0.251525] omap_hwmod: gpio2: softreset failed (waited 10000 usec)
> > > [ 0.265594] omap_hwmod: gpio3: softreset failed (waited 10000 usec)
> > > [ 0.279693] omap_hwmod: gpio4: softreset failed (waited 10000 usec)
> > > [ 0.293762] omap_hwmod: gpio5: softreset failed (waited 10000 usec)
> > > [ 0.307861] omap_hwmod: gpio6: softreset failed (waited 10000 usec)
Hi Paul,
I tested this on one more board and still got these softreset warnings.
So this wasn't a board specific issue and debugged into what is causing
these.
The problem is the FCLK isn't enabled for these gpios(2..6) while
resetting. So the GPIO's are not resetting properly. Once i enable FCLK
for them and then set the SYSCONFIG.SOFTRESET, then they are resetting
and it is reflected in RESETDONE bit.
That being said, I was looking for accessing gpio2_fck in the
gpio2_hwmod. But i find the structure as below,
static struct omap_hwmod omap3xxx_gpio2_hwmod = {
.name = "gpio2",
.mpu_irqs = omap3xxx_gpio2_irqs,
.mpu_irqs_cnt = ARRAY_SIZE(omap3xxx_gpio2_irqs),
.main_clk = "gpio2_ick",
Is there any reason, why 'iclk' is set as the 'main_clk' and not 'fclk'.
Also 'fclk' is structured as 'gpio2_dbck' and made as an optional clock.
I wasn't very sure, why the name 'dbck'?
> >
> > Just FYI, I don't see the gpio softreset failures on my boards here.
Most likely you aren't seeing this in N800 and beagle because the
bootloader may be enabling the clocks.
I am sorry if the above question seems silly. I am fairly new to this
frameworks and hence the question :-). Please clarify.
br ,
- avinash
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
