On Wed, Mar 2, 2011 at 2:15 AM, Samuel Ortiz <[email protected]> wrote:
> Hi Keerthy,
>
> On Tue, Mar 01, 2011 at 07:12:06PM +0530, Keerthy wrote:
>> MADC(Monitoring ADC) driver enables monitoring analog signals using
>> analog-to-digital conversion (ADC) on the input source.
>> The previous discussion concluded in keeping the generic ADC
>> functionality and the hwmon separate. The discussion can be found here:
>>
>> http://www.mail-archive.com/[email protected]/msg41805.html
> Thanks a lot, I applied those 2 patches.
I'm attempting to use this drive on the Overo platform with 2.6.39-rc5.
Other than enabling the module with CONFIG_SENSORS_TWL4030_MADC=m are
there any board file modifications required other than the below?
I have setup the platform data for the twl4030 madc driver:
diff --git a/arch/arm/mach-omap2/board-overo.c
b/arch/arm/mach-omap2/board-overo.c
index 112dfc9..05dd3eb 100644
--- a/arch/arm/mach-omap2/board-overo.c
+++ b/arch/arm/mach-omap2/board-overo.c
@@ -637,10 +637,15 @@ static struct twl4030_codec_data overo_codec_data = {
.audio = &overo_audio_data,
};
+static struct twl4030_madc_platform_data overo_madc_data = {
+ .irq_line = 1,
+};
+
static struct twl4030_platform_data overo_twldata = {
.irq_base = TWL4030_IRQ_BASE,
.irq_end = TWL4030_IRQ_END,
.gpio = &overo_gpio_data,
+ .madc = &overo_madc_data,
.usb = &overo_usb_data,
.codec = &overo_codec_data,
.vmmc1 = &overo_vmmc1,
However, I am not seeing the sysfs entry created:
# modprobe twl4030-madc-hwmon
twl4030_madc_hwmon_init entry
# lsmod
Module Size Used by
twl4030_madc_hwmon 2594 0
ipv6 224256 16
libertas_sdio 14867 0
libertas 92429 1 libertas_sdio
cfg80211 144256 1 libertas
lib80211 5027 1 libertas
firmware_class 5859 2 libertas_sdio,libertas
# ls /sys/class/hwmon/
#
I added a couple of printk's to the driver at the entry points of init
and probe, and as you can see above the init message is printed, but
not the probe.
Am I missing something really obvious here?
Steve
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
