On 05/12/11 04:01, Peter Ujfalusi wrote:
> On Thursday 12 May 2011 09:25:55 Jarkko Nikula wrote:
>> Of course for this you need to use omap as a master and codec as a
>> slave. One example for this is sound/soc/omap/omap3pandora.c.
>>
>> static struct omap_board_mux board_mux[] __initdata = {
>> + OMAP3_MUX(MCBSP1_FSX, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
>> + OMAP3_MUX(MCBSP1_CLKX, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
>> + OMAP3_MUX(MCBSP1_DR, OMAP_MUX_MODE0 | OMAP_PIN_INPUT),
>> + OMAP3_MUX(MCBSP1_DX, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
>> +
>
> I think the CLKX, FSX need to be input, since the config suggests,t that
> McBSP1 is the slave port:
>
>> [ 1566.123962] omap-mcbsp omap-mcbsp.1: PCR0: 0x0f0f
>
Hi, thanks for trying to help.
I already tried that, but it still did not xmit. Now I wonder about
master/slave. I thought that the omap is set up as a master. I looked at
PCR0 docs in the tech ref manual and I get:
11 FSXM Transmit Frame-Synchronization Mode RW 0x0
0x0: Frame-synchronization signal derived from an
external source
0x1: Frame synchronization is determined by the SRG
frame-synchronization mode bit FSGM in SRGR2.
10 FSRM Receive Frame-Synchronization Mode RW 0x0
0x0: Frame-Synchronization pulses generated by an
external device. FSR is an input pin.
0x1: Frame synchronization generated internally by SRG.
FSR is an output pin except when GSYNC=1 in SRGR.
Etc.
Since it is set to 0xF0F, doesn't this set it as master?
Also, spelunking the kernel sources, I cannot seem to find the source
for mcbsp_data->regs -- do you know where it gets set initially?
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
