On Tue, 2011-12-13 at 09:52 +0200, Alex wrote: > This patch adds DSS2 support to the LogicPD OMAP 35x Torpedo boardfile. LCD > and > TV-out are supported. > > Signed-off-by: Alex Gershgorin <[email protected]>
Overall looks fine. A few questions below about the GPIOs, though.
<snip>
> +static void __init omap3logic_display_init(void)
> +{
> + int r;
> +
> + r = gpio_request_array(omap3logic_dss_gpios,
> + ARRAY_SIZE(omap3logic_dss_gpios));
> + if (r) {
> + printk(KERN_ERR "failed to get lcd_panel_* gpios\n");
> + return;
> + }
> +
> + gpio_export(OMAP3_TORPEDO_LCD_BACKLIGHT_GPIO, 0);
> + gpio_export(OMAP3_TORPEDO_LCD_ENABLE_GPIO, 0);
> + gpio_export(OMAP3_TORPEDO_LCD_PWM_GPIO, 0);
Why do you want to export these GPIOs? They are handled here in the
board file, and I don't think there's any reason the userspace would
need to touch them.
> + gpio_set_value(OMAP3_TORPEDO_LCD_BACKLIGHT_GPIO, 0);
> + gpio_set_value(OMAP3_TORPEDO_LCD_ENABLE_GPIO, 0);
> + gpio_set_value(OMAP3_TORPEDO_LCD_PWM_GPIO, 0);
These are already set to 0 in gpio_request_array, as you've defined the
flag "GPIOF_OUT_INIT_LOW".
> +
> + msleep(50);
> + gpio_set_value(OMAP3_TORPEDO_LCD_PWM_GPIO, 1);
What does this do, and why do you need msleep(50)? I understand
LCD_ENABLE gpio enables the LCD panel, but what exactly do LCD_BACKLIGHT
and LCD_PWM gpios do? Why don't you set/unset LCD_PWM in the panel
enable/disable functions like the other gpios?
Tomi
signature.asc
Description: This is a digitally signed message part
