TWL6030 family of PMIC use a shadow interrupt status register
while kernel processes the current interrupt event.
However, any write(0 or 1) to register INT_STS_A, INT_STS_B or
INT_STS_C clears all 3 interrupt status registers.
Since clear of the interrupt is done on 32k clk, depending on I2C
bus speed, we could in-adverently clear the status of a interrupt
status pending on shadow register in the current implementation.
This is due to the fact that multi-byte i2c write operation into
three seperate status register could result in multiple load
and clear of status and result in lost interrupts.
Instead, doing a single byte write to INT_STS_A register with 0x0
will clear all three interrupt status registers without the related
risk.
Acked-by: Santosh Shilimkar <santosh.shilim...@ti.com>
Signed-off-by: Nishanth Menon <n...@ti.com>
---
drivers/mfd/twl6030-irq.c | 13 +++++++++++--
1 files changed, 11 insertions(+), 2 deletions(-)
diff --git a/drivers/mfd/twl6030-irq.c b/drivers/mfd/twl6030-irq.c
index c6b456a..aa367a2 100644
--- a/drivers/mfd/twl6030-irq.c
+++ b/drivers/mfd/twl6030-irq.c
@@ -185,8 +185,17 @@ static int twl6030_irq_thread(void *data)
}
local_irq_enable();
}
- ret = twl_i2c_write(TWL_MODULE_PIH, sts.bytes,
- REG_INT_STS_A, 3); /* clear INT_STS_A */
+
+ /*
+ * NOTE:
+ * Simulation confirms that documentation is wrong w.r.t the
+ * interrupt status clear operation. A single *byte* write to
+ * any one of STS_A to STS_C register results in all three
+ * STS registers being reset. Since it does not matter which
+ * value is written, all three registers are cleared on a
+ * single byte write, so we just use 0x0 to clear.
+ */
+ ret = twl_i2c_write_u8(TWL_MODULE_PIH, 0x00, REG_INT_STS_A);
if (ret)
pr_warning("twl6030: I2C error in clearing PIH ISR\n");
--
1.7.5.4
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
