Hi, On Tue, 21 Aug 2012 16:42:19 +0300 Peter Ujfalusi <[email protected]> wrote:
> On 08/21/2012 08:42 AM, Andreas Kemnade wrote:
> > Hi,
> >
> > I tried a couple of times with different kernels to use mcbsp1 of dm3730
> > in master mode (so that it sends out clocks).
> > The result always is that I can send data out. but arecord gets no input. It
> > waits for input but does not get anything, although clocks are generated,
> > checked that with a scope.
> >
> > I even took a driver which works in master mode on another mcbsp and just
> > changed
> > the mcbsp number.
> > What needs to be done to receive data from mcbsp1?
>
> You should check the PIN mux configuration of McBSP1 FSR/CLKR pins. McBSP1 on
> dm3730 have 6 pin configuration. I think the capture should work fine if you
> select the FSX as FSR source, and CLKX as CLKR source.
>
if I understand the TRM correctly, according to Figure 21-26 in chapter
21.4.2.3.
if GSYNC is set, the receiver uses the signal from the sample rate generator,
so CLKX does not need to be the CLKR source.
But I tried also with the DEVCONF0 MCBSP1_CLKR bit as you proposed.
I tried
snd_soc_dai_set_sysclk(cpu_dai, OMAP_MCBSP_CLKR_SRC_CLKX, 0,
SND_SOC_CLOCK_OUT);
snd_soc_dai_set_sysclk(cpu_dai, OMAP_MCBSP_FSR_SRC_FSX, 0,
SND_SOC_CLOCK_OUT);
That is why I send you my patch about that mux settings. But I had no success.
The CLKX as CLKR source and FSX as FSR source setting I have only seen when
mcbsp1 is used in slave mode. If you know any working code which uses mcbsp1 in
master mode then let me know.
Greetings
Andreas Kemnade
signature.asc
Description: PGP signature
